# Copyright (c) 2021 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

include: sensor-device.yaml

properties:
  irq-gpios:
    type: phandle-array
    description: |
      DRDY pin

      This pin defaults to active high when produced by the sensor.
      The property value should ensure the flags properly describe
      the signal that is presented to the driver.

  range:
    type: int
    default: 2
    description: |
      Range in g. Default is power-up configuration.

    enum:
      - 16 # 16g (0.488 mg/LSB)
      - 8  #  8g (0.244 mg/LSB)
      - 4  #  4g (0.122 mg/LSB)
      - 2  #  2g (0.061 mg/LSB)

  power-mode:
    type: int
    default: 0
    description: |
      Specify the sensor power mode. Default is power-down mode

    enum:
      - 0 # Power Down (PD)
      - 1 # Low Power (LP)
      - 2 # High Resolution (HR)
      - 3 # High Frequency (HF)

  odr:
    type: int
    default: 0
    description: |
        Specify the default output data rate expressed in samples per second (Hz).
        Default is power-down mode
    enum:
      - 0  # Power-Down
      - 1  # 1Hz (available in LP mode only)
      - 2  # 12.5Hz (available in LP and HR mode)
      - 3  # 25Hz (available in LP and HR mode)
      - 4  # 50Hz (available in LP and HR mode)
      - 5  # 100Hz (available in LP and HR mode)
      - 6  # 200Hz (available in LP and HR mode)
      - 7  # 400Hz (available in LP and HR mode)
      - 8  # 800Hz (available in LP and HR mode)
      - 9  # 1600Hz (available in HF mode only)
      - 10  # 3200Hz (available in HF mode only)
      - 11  # 6400Hz (available in HF mode only)