# Copyright (c), 2023 Nordic Semiconductor ASA
# SPDX -License-Identifier: Apache-2.0

description: |
  Nordic nPM1300 PMIC

  The PMIC has two buck converters and two LDOs.
  The regulators need to be defined as child nodes, strictly following the
  BUCK1,2 LDO1..2, node names. For
  example:

  pmic@6b {
    reg = <0x6b>;
    ...
    regulators {
      compatible = "nordic,npm1300-regulator";

      BUCK1 {
        /* all properties for BUCK1 */
      };
      BUCK2 {
        /* all properties for BUCK2 */
      };
      LDO1 {
        /* all properties for LDO1 */
      };
      LDO2 {
        /* all properties for LDO2 */
      };
    };
  };

compatible: "nordic,npm1300-regulator"

include: base.yaml

properties:
  dvs-gpios:
    type: phandle-array
    description: |
      List of SOC GPIOs connected to PMIC GPIOs.
      Set_dvs_mode will drive these pins as follows:
        DVS mode 1 will enable the first pin
        DVS mode 2 will enable the second pin
        DVS mode 3 will drive the first and second pins
        etc.
      The effect of the mode change is defined by the enable-gpios
      and pwm_gpios fields for each of the regulator blocks.

child-binding:
  include:
    - name: regulator.yaml
      property-allowlist:
        - regulator-always-on
        - regulator-boot-on
        - regulator-min-microvolt
        - regulator-max-microvolt
        - regulator-init-microvolt
        - regulator-allowed-modes
        - regulator-initial-mode
        - regulator-min-microamp
        - regulator-max-microamp
        - startup-delay-us
        - off-on-delay-us

  properties:
    retention-microvolt:
      type: int
      description: |
        Retention mode voltage in microvolts.

    enable-gpios:
      type: phandle-array
      description: |
        Regulator enable controlled by specified regulator GPIO pin.
        When set regulator must be enabled/disabled using set_dvs_mode.

    pwm-gpios:
      type: phandle-array
      description: |
        Regulator enable controlled by specified regulator GPIO pin.
        When set regulator must be enabled/disabled using set_dvs_mode.

    retention-gpios:
      type: phandle-array
      description: |
        Retention mode controlled by specified regulator GPIO pin.

    soft-start-microamp:
      type: int
      enum:
        - 10000
        - 20000
        - 35000
        - 50000
      description: |
        Soft start current limit in microamps.