# SPDX-License-Identifier: Apache-2.0

CONFIG_SOC_SERIES_STM32F3X=y
CONFIG_SOC_STM32F303XE=y
# 72 MHz system clock
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000

CONFIG_SERIAL=y

# Enable MPU
CONFIG_ARM_MPU=y

# Enable HW stack protection
CONFIG_HW_STACK_PROTECTION=y

# console
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y

# enable pinmux
CONFIG_PINMUX=y

# enable GPIO
CONFIG_GPIO=y

# clock configuration
CONFIG_CLOCK_CONTROL=y

# Clock configuration for Cube Clock control driver
CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
# use HSE as PLL input
CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
# however, the board does not have an external oscillator, so just use
# the 8MHz clock signal coming from integrated STLink
CONFIG_CLOCK_STM32_HSE_BYPASS=y
# produce 72MHz clock at PLL output
CONFIG_CLOCK_STM32_PLL_PREDIV1=1
CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9
CONFIG_CLOCK_STM32_AHB_PRESCALER=1
CONFIG_CLOCK_STM32_APB1_PRESCALER=2
CONFIG_CLOCK_STM32_APB2_PRESCALER=1