| /* | |
| * Copyright 2018 NXP | |
| * All rights reserved. | |
| * | |
| * | |
| * SPDX-License-Identifier: BSD-3-Clause | |
| */ | |
| #ifndef __SERIAL_PORT_UART_H__ | |
| #define __SERIAL_PORT_UART_H__ | |
| /******************************************************************************* | |
| * Definitions | |
| ******************************************************************************/ | |
| #if (defined(SERIAL_MANAGER_NON_BLOCKING_MODE) && (SERIAL_MANAGER_NON_BLOCKING_MODE > 0U)) | |
| #define SERIAL_PORT_UART_HANDLE_SIZE (166U) | |
| #else | |
| #define SERIAL_PORT_UART_HANDLE_SIZE (4U) | |
| #endif | |
| typedef enum _serial_port_uart_parity_mode | |
| { | |
| kSerialManager_UartParityDisabled = 0x0U, /*!< Parity disabled */ | |
| kSerialManager_UartParityEven = 0x1U, /*!< Parity even enabled */ | |
| kSerialManager_UartParityOdd = 0x2U, /*!< Parity odd enabled */ | |
| } serial_port_uart_parity_mode_t; | |
| typedef enum _serial_port_uart_stop_bit_count | |
| { | |
| kSerialManager_UartOneStopBit = 0U, /*!< One stop bit */ | |
| kSerialManager_UartTwoStopBit = 1U, /*!< Two stop bits */ | |
| } serial_port_uart_stop_bit_count_t; | |
| typedef struct _serial_port_uart_config | |
| { | |
| uint32_t clockRate; /*!< clock rate */ | |
| uint32_t baudRate; /*!< baud rate */ | |
| serial_port_uart_parity_mode_t parityMode; /*!< Parity mode, disabled (default), even, odd */ | |
| serial_port_uart_stop_bit_count_t stopBitCount; /*!< Number of stop bits, 1 stop bit (default) or 2 stop bits */ | |
| uint8_t instance; /*!< Instance (0 - UART0, 1 - UART1, ...), detail information | |
| please refer to the SOC corresponding RM. */ | |
| uint8_t enableRx; /*!< Enable RX */ | |
| uint8_t enableTx; /*!< Enable TX */ | |
| } serial_port_uart_config_t; | |
| #endif /* __SERIAL_PORT_UART_H__ */ |