[HAL][UART] Disable the Receiver Timeout Interrupt when data reception is completed
diff --git a/Src/stm32f3xx_hal_uart.c b/Src/stm32f3xx_hal_uart.c
index aaa9182..136a74a 100644
--- a/Src/stm32f3xx_hal_uart.c
+++ b/Src/stm32f3xx_hal_uart.c
@@ -3822,6 +3822,13 @@
/* Initialize type of RxEvent to Transfer Complete */
huart->RxEventType = HAL_UART_RXEVENT_TC;
+ /* Check that USART RTOEN bit is set */
+ if (READ_BIT(huart->Instance->CR2, USART_CR2_RTOEN) != 0U)
+ {
+ /* Enable the UART Receiver Timeout Interrupt */
+ ATOMIC_CLEAR_BIT(huart->Instance->CR1, USART_CR1_RTOIE);
+ }
+
/* Check current reception Mode :
If Reception till IDLE event has been selected : */
if (huart->ReceptionType == HAL_UART_RECEPTION_TOIDLE)
@@ -3905,6 +3912,13 @@
/* Initialize type of RxEvent to Transfer Complete */
huart->RxEventType = HAL_UART_RXEVENT_TC;
+ /* Check that USART RTOEN bit is set */
+ if (READ_BIT(huart->Instance->CR2, USART_CR2_RTOEN) != 0U)
+ {
+ /* Enable the UART Receiver Timeout Interrupt */
+ ATOMIC_CLEAR_BIT(huart->Instance->CR1, USART_CR1_RTOIE);
+ }
+
/* Check current reception Mode :
If Reception till IDLE event has been selected : */
if (huart->ReceptionType == HAL_UART_RECEPTION_TOIDLE)