| CFLAGS += \ |
| -mthumb \ |
| -mabi=aapcs \ |
| -mcpu=cortex-m0plus \ |
| -DCPU_LPC51U68JBD64 \ |
| -DCFG_TUSB_MCU=OPT_MCU_LPC51UXX \ |
| -DCFG_TUSB_MEM_SECTION='__attribute__((section(".data")))' \ |
| -DCFG_TUSB_MEM_ALIGN='__attribute__((aligned(64)))' |
| |
| # mcu driver cause following warnings |
| CFLAGS += -Wno-error=nested-externs -Wno-error=unused-parameter |
| |
| MCU_DIR = hw/mcu/nxp/lpc_driver/sdk/devices/LPC51U68 |
| |
| # All source paths should be relative to the top level. |
| LD_FILE = $(MCU_DIR)/gcc/LPC51U68_flash.ld |
| |
| SRC_C += \ |
| $(MCU_DIR)/system_LPC51U68.c \ |
| $(MCU_DIR)/drivers/fsl_clock.c \ |
| $(MCU_DIR)/drivers/fsl_gpio.c \ |
| $(MCU_DIR)/drivers/fsl_power.c \ |
| $(MCU_DIR)/drivers/fsl_reset.c |
| |
| INC += \ |
| $(TOP)/$(MCU_DIR)/../../CMSIS/Include \ |
| $(TOP)/$(MCU_DIR) \ |
| $(TOP)/$(MCU_DIR)/drivers |
| |
| SRC_S += $(MCU_DIR)/gcc/startup_LPC51U68.S |
| |
| LIBS += $(TOP)/$(MCU_DIR)/gcc/libpower.a |
| |
| # For TinyUSB port source |
| VENDOR = nxp |
| CHIP_FAMILY = lpc_ip3511 |
| |
| # For freeRTOS port source |
| FREERTOS_PORT = ARM_CM0 |
| |
| # For flash-jlink target |
| JLINK_DEVICE = LPC51U68 |
| JLINK_IF = swd |
| |
| # flash using pyocd (51u68 is not supported yet) |
| flash: $(BUILD)/$(BOARD)-firmware.hex |
| pyocd flash -t LPC51U68 $< |
