| DEPS_SUBMODULES += hw/mcu/nxp/lpcopen |
| |
| CFLAGS += \ |
| -flto \ |
| -mthumb \ |
| -mabi=aapcs \ |
| -mcpu=cortex-m0 \ |
| -nostdlib \ |
| -DCORE_M0 \ |
| -D__USE_LPCOPEN \ |
| -DCFG_EXAMPLE_MSC_READONLY \ |
| -DCFG_TUSB_MCU=OPT_MCU_LPC11UXX \ |
| -DCFG_TUSB_MEM_SECTION='__attribute__((section(".data.$$RAM2")))' \ |
| -DCFG_TUSB_MEM_ALIGN='__attribute__((aligned(64)))' |
| |
| # mcu driver cause following warnings |
| CFLAGS += -Wno-error=strict-prototypes -Wno-error=unused-parameter |
| |
| MCU_DIR = hw/mcu/nxp/lpcopen/lpc11uxx/lpc_chip_11uxx |
| |
| # All source paths should be relative to the top level. |
| LD_FILE = hw/bsp/$(BOARD)/lpc11u37.ld |
| |
| SRC_C += \ |
| src/portable/nxp/lpc_ip3511/dcd_lpc_ip3511.c \ |
| $(MCU_DIR)/../gcc/cr_startup_lpc11xx.c \ |
| $(MCU_DIR)/src/chip_11xx.c \ |
| $(MCU_DIR)/src/clock_11xx.c \ |
| $(MCU_DIR)/src/gpio_11xx_1.c \ |
| $(MCU_DIR)/src/iocon_11xx.c \ |
| $(MCU_DIR)/src/sysctl_11xx.c \ |
| $(MCU_DIR)/src/sysinit_11xx.c |
| |
| INC += \ |
| $(TOP)/$(MCU_DIR)/inc |
| |
| # For freeRTOS port source |
| FREERTOS_PORT = ARM_CM0 |
| |
| # For flash-jlink target |
| JLINK_DEVICE = LPC11U37/401 |
| |
| # flash using pyocd |
| flash: $(BUILD)/$(PROJECT).hex |
| pyocd flash -t lpc11u37 $< |
