| # |
| # Copyright (c) 2022 Project CHIP Authors |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| # This sample uses Kconfig.defaults to set options common for all |
| # samples. This file should contain only options specific for this sample |
| # or overrides of default values. |
| |
| # Enable CHIP |
| CONFIG_CHIP=y |
| CONFIG_CHIP_PROJECT_CONFIG="main/include/CHIPProjectConfig.h" |
| # 32784 == 0x8010 (example window-app) |
| CONFIG_CHIP_DEVICE_PRODUCT_ID=32784 |
| CONFIG_STD_CPP14=y |
| |
| # Add support for LEDs and buttons on Nordic development kits |
| CONFIG_DK_LIBRARY=y |
| CONFIG_PWM=y |
| |
| # PWM support |
| CONFIG_PWM=y |
| |
| # OpenThread configs |
| CONFIG_OPENTHREAD_NORDIC_LIBRARY_MTD=y |
| CONFIG_OPENTHREAD_MTD=y |
| CONFIG_OPENTHREAD_FTD=n |
| CONFIG_CHIP_ENABLE_SLEEPY_END_DEVICE_SUPPORT=y |
| CONFIG_CHIP_THREAD_SSED=y |
| CONFIG_CHIP_SED_IDLE_INTERVAL=500 |
| CONFIG_CHIP_SED_ACTIVE_INTERVAL=500 |
| |
| # Bluetooth Low Energy configuration |
| CONFIG_BT_DEVICE_NAME="MatterWinCov" |
| |
| # Enable system reset on fatal error |
| CONFIG_RESET_ON_FATAL_ERROR=y |
| |
| # Stack size settings |
| CONFIG_IEEE802154_NRF5_RX_STACK_SIZE=1024 |
| |
| # Suspend devices when the CPU goes into sleep |
| CONFIG_PM_DEVICE=y |
| |
| # Disable all debug features |
| CONFIG_SHELL=n |
| CONFIG_OPENTHREAD_SHELL=n |
| CONFIG_CONSOLE=n |
| CONFIG_UART_CONSOLE=n |
| CONFIG_SERIAL=n |
| CONFIG_LOG=n |
| CONFIG_LOG_MODE_MINIMAL=n |
| CONFIG_ASSERT_VERBOSE=n |
| CONFIG_ASSERT_NO_FILE_INFO=y |
| CONFIG_PRINTK=n |
| CONFIG_PRINTK_SYNC=n |
| CONFIG_THREAD_NAME=n |