| # |
| # Copyright (c) 2021-2023 Project CHIP Authors |
| # All rights reserved. |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| # Description: |
| # Some useful defaults for the demo app configuration. |
| # |
| CONFIG_IDF_TARGET="esp32" |
| CONFIG_IDF_TARGET_ESP32=y |
| CONFIG_DEVICE_TYPE_M5STACK=y |
| |
| # Default to 921600 baud when flashing and monitoring device |
| CONFIG_ESPTOOLPY_BAUD_921600B=y |
| CONFIG_ESPTOOLPY_BAUD=921600 |
| CONFIG_ESPTOOLPY_COMPRESSED=y |
| CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y |
| CONFIG_ESPTOOLPY_MONITOR_BAUD=115200 |
| |
| #enable BT |
| CONFIG_BT_ENABLED=y |
| CONFIG_BT_NIMBLE_ENABLED=y |
| |
| #disable BT connection reattempt |
| CONFIG_BT_NIMBLE_ENABLE_CONN_REATTEMPT=n |
| |
| #enable lwip ipv6 autoconfig |
| CONFIG_LWIP_IPV6_AUTOCONFIG=y |
| |
| #enable debug shell |
| CONFIG_ENABLE_CHIP_SHELL=y |
| |
| # Use a custom partition table |
| CONFIG_PARTITION_TABLE_CUSTOM=y |
| CONFIG_PARTITION_TABLE_FILENAME="partitions.csv" |
| |
| #enable lwIP route hooks |
| CONFIG_LWIP_HOOK_IP6_ROUTE_DEFAULT=y |
| CONFIG_LWIP_HOOK_ND6_GET_GW_DEFAULT=y |
| |
| # Main task needs a bit more stack than the default |
| # default is 3584, bump this up to 5k. |
| CONFIG_ESP_MAIN_TASK_STACK_SIZE=5120 |
| |
| # Serial Flasher config |
| CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y |
| CONFIG_ESPTOOLPY_FLASHSIZE="4MB" |
| |
| # Disable softap support by default |
| CONFIG_ESP_WIFI_SOFTAP_SUPPORT=n |
| # This example uses the older version of RMT driver to work with both |
| # idf-v4.4.3 and idf-v5.0, so supressing the warnings by setting below option |
| CONFIG_RMT_SUPPRESS_DEPRECATE_WARN=y |
| |
| # Enable HKDF in mbedtls |
| CONFIG_MBEDTLS_HKDF_C=y |
| |
| # Optimize IRAM |
| CONFIG_FREERTOS_PLACE_FUNCTIONS_INTO_FLASH=y |
| |
