blob: e2ec051d774fe1646d2f103d311c8173336c431e [file] [log] [blame]
#
# Copyright (c) 2020 Project CHIP Authors
# All rights reserved.
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#
# Description:
# Configuration options CHIP ESP32 demo application.
#
menu "Demo"
choice
prompt "Rendezvous Mode"
default RENDEZVOUS_MODE_BLE
help
Specifies the Rendezvous mode of the peripheral.
config RENDEZVOUS_MODE_WIFI
bool "Wi-Fi"
config RENDEZVOUS_MODE_BLE
bool "BLE"
config RENDEZVOUS_MODE_THREAD
bool "Thread"
config RENDEZVOUS_MODE_ETHERNET
bool "Ethernet"
endchoice
config USE_ECHO_CLIENT
bool "Enable the built-in Echo Client"
default "n"
help
This enables a local FreeRTOS Echo Client so that the end-to-end echo server can be
tested easily
config ECHO_HOST_IP
string "IPV4 address"
default "127.0.0.1"
depends on USE_ECHO_CLIENT
help
The IPV4 Address of the ECHO Server.
config RENDEZVOUS_MODE
int
range 0 8
default 1 if RENDEZVOUS_MODE_WIFI
default 2 if RENDEZVOUS_MODE_BLE
default 4 if RENDEZVOUS_MODE_THREAD
default 8 if RENDEZVOUS_MODE_ETHERNET
endmenu
menu "PW RPC Debug channel"
depends on ENABLE_PW_RPC
config EXAMPLE_UART_PORT_NUM
int "UART port number"
range 0 2 if IDF_TARGET_ESP32
range 0 1 if IDF_TARGET_ESP32C3
default 0
help
UART communication port number for the example.
See UART documentation for available port numbers.
config EXAMPLE_UART_BAUD_RATE
int "UART communication speed"
range 1200 115200
default 115200
help
UART communication speed for Modbus example.
config EXAMPLE_UART_RXD
int "UART RXD pin number"
range 0 34 if IDF_TARGET_ESP32
range 0 19 if IDF_TARGET_ESP32C3
default 5
help
GPIO number for UART RX pin. See UART documentation for more information
about available pin numbers for UART.
config EXAMPLE_UART_TXD
int "UART TXD pin number"
range 0 34 if IDF_TARGET_ESP32
range 0 19 if IDF_TARGET_ESP32C3
default 4
help
GPIO number for UART TX pin. See UART documentation for more information
about available pin numbers for UART.
endmenu