blob: 0f14b694c3909390898fa79a2e3c7e46bc070e65 [file] [log] [blame]
/*
*
* Copyright (c) 2022 Project CHIP Authors
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#include "Button.h"
#define GPIO_INPUT_IO_0 CONFIG_EXAMPLE_BOARD_BUTTON_GPIO
#define GPIO_INPUT_PIN_SEL (1ULL << GPIO_INPUT_IO_0)
#define ESP_INTR_FLAG_DEFAULT 0
static const char * TAG = "Button";
static Button::ButtonPressCallback button_press_handler = nullptr;
static void gpio_isr_handler(void * arg)
{
if (button_press_handler != nullptr)
{
button_press_handler();
}
}
void Button::Init()
{
/* Initialize button interrupt*/
// zero-initialize the config structure.
gpio_config_t io_conf = {};
// interrupt of rising edge
io_conf.intr_type = GPIO_INTR_NEGEDGE;
// bit mask of the pins, use GPIO4/5 here
io_conf.pin_bit_mask = GPIO_INPUT_PIN_SEL;
// set as input mode
io_conf.mode = GPIO_MODE_INPUT;
// enable pull-up mode
io_conf.pull_up_en = GPIO_PULLUP_ENABLE;
gpio_config(&io_conf);
// install gpio isr service
gpio_install_isr_service(ESP_INTR_FLAG_DEFAULT);
// hook isr handler for specific gpio pin
gpio_isr_handler_add(static_cast<gpio_num_t>(GPIO_INPUT_IO_0), gpio_isr_handler, (void *) GPIO_INPUT_IO_0);
ESP_LOGI(TAG, "Button initialized..");
}
void Button::SetButtonPressCallback(ButtonPressCallback button_callback)
{
if (button_callback != nullptr)
{
button_press_handler = button_callback;
}
}