blob: 56fed5d65e679795d6c01b13efc334b2cb212cce [file] [log] [blame]
#
# Copyright (c) 2020 Project CHIP Authors
# Copyright (c) 2018 Nest Labs, Inc.
# All rights reserved.
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#
# Description:
# CI uses this to select the ESP32 M5Stack.
#
CONFIG_IDF_TARGET="esp32"
CONFIG_IDF_TARGET_ESP32=y
CONFIG_DEVICE_TYPE_M5STACK=y
# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200
#enable BT
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y
#enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y
# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions.csv"
# Vendor and product id
CONFIG_DEVICE_VENDOR_ID=0xFFF1
CONFIG_DEVICE_PRODUCT_ID=0x8001
# Main task needs a bit more stack than the default
# default is 3584, bump this up to 5k.
CONFIG_ESP_MAIN_TASK_STACK_SIZE=5120
# PW RPC Debug channel
CONFIG_EXAMPLE_UART_PORT_NUM=0
CONFIG_EXAMPLE_UART_BAUD_RATE=115200
CONFIG_EXAMPLE_UART_RXD=3
CONFIG_EXAMPLE_UART_TXD=1
CONFIG_ENABLE_PW_RPC=y
# Disable shell
CONFIG_ENABLE_CHIP_SHELL=n
# Serial Flasher config
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"
#disable Bluetooth modem sleep
#enable it may cause GPIO ISR triggers continuously
CONFIG_BTDM_CTRL_MODEM_SLEEP=n
CONFIG_BTDM_CTRL_MODEM_SLEEP_MODE_ORIG=n
CONFIG_BTDM_CTRL_LPCLK_SEL_MAIN_XTAL=n
# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y
# Build chip tests
CONFIG_BUILD_CHIP_TESTS=y
# Move functions from IRAM to flash
CONFIG_FREERTOS_PLACE_FUNCTIONS_INTO_FLASH=y
# to avoid dram overflow, reduce the critical loggin buffer to 1K
CONFIG_EVENT_LOGGING_CRIT_BUFFER_SIZE=1024
CONFIG_DIAG_USE_EXTERNAL_LOG_WRAP=y