blob: 73f8d8cf318a650245d6b1270f6b96e48936c36e [file] [log] [blame]
#
# Copyright (c) 2022 Project CHIP Authors
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#
mainmenu "Matter nRF Connect Light Switch Example Application"
config STATE_LEDS
bool "Use LEDs to indicate the device state"
default y
help
Use LEDs to render the current state of the device such as the progress of commissioning of
the device into a network or the factory reset initiation. Note that setting this option to
'n' does not disable the LED indicating the state of the simulated bolt.
# Sample configuration used for Thread networking
if NET_L2_OPENTHREAD
choice OPENTHREAD_NORDIC_LIBRARY_CONFIGURATION
default OPENTHREAD_NORDIC_LIBRARY_MTD
endchoice
choice OPENTHREAD_DEVICE_TYPE
default OPENTHREAD_MTD
endchoice
config CHIP_ENABLE_SLEEPY_END_DEVICE_SUPPORT
bool
default y
endif # NET_L2_OPENTHREAD
if CHIP_WIFI
config NRF_WIFI_LOW_POWER
default y
endif # CHIP_WIFI
config CHIP_ICD_SUBSCRIPTION_HANDLING
default y
rsource "../../../config/nrfconnect/chip-module/Kconfig.features"
rsource "../../../config/nrfconnect/chip-module/Kconfig.defaults"
source "Kconfig.zephyr"