blob: 6a06f08a0d51fb4daba36f95aa23b68750bce8fb [file] [log] [blame]
#
# Copyright (c) 2020 Project CHIP Authors
# Copyright (c) 2018 Nest Labs, Inc.
# All rights reserved.
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#
# Description:
# Some useful defaults for the demo app configuration.
#
# Default to 921600 baud when flashing and monitoring device
CONFIG_ESPTOOLPY_BAUD_921600B=y
CONFIG_ESPTOOLPY_BAUD=921600
CONFIG_ESPTOOLPY_COMPRESSED=y
CONFIG_ESPTOOLPY_MONITOR_BAUD_115200B=y
CONFIG_ESPTOOLPY_MONITOR_BAUD=115200
#enable BT
CONFIG_BT_ENABLED=y
CONFIG_BT_NIMBLE_ENABLED=y
#disable BT connection reattempt
CONFIG_BT_NIMBLE_ENABLE_CONN_REATTEMPT=n
#enable lwip ipv6 autoconfig
CONFIG_LWIP_IPV6_AUTOCONFIG=y
# Use a custom partition table
CONFIG_PARTITION_TABLE_CUSTOM=y
CONFIG_PARTITION_TABLE_FILENAME="partitions.csv"
# Add RTC memory to system heap
CONFIG_ESP_SYSTEM_ALLOW_RTC_FAST_MEM_AS_HEAP=y
# Product id
CONFIG_DEVICE_VENDOR_ID=0xFFF1
CONFIG_DEVICE_PRODUCT_ID=0x8007
# Main task needs a bit more stack than the default
# default is 3584, bump this up to 6k.
CONFIG_ESP_MAIN_TASK_STACK_SIZE=6144
# Serial Flasher config
CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y
CONFIG_ESPTOOLPY_FLASHSIZE="4MB"
# discriminator
CONFIG_USE_TEST_SETUP_DISCRIMINATOR=0xF01
# Enable chip shell
CONFIG_ENABLE_CHIP_SHELL=y
# Disable softap support by default
CONFIG_ESP_WIFI_SOFTAP_SUPPORT=n
# Enable HKDF in mbedtls
CONFIG_MBEDTLS_HKDF_C=y
# Increase LwIP IPv6 address number
CONFIG_LWIP_IPV6_NUM_ADDRESSES=6