examples/light-switch-app/nrfconnect/prj_release.conf

#
#    Copyright (c) 2022 Project CHIP Authors
#
#    Licensed under the Apache License, Version 2.0 (the "License");
#    you may not use this file except in compliance with the License.
#    You may obtain a copy of the License at
#
#        http://www.apache.org/licenses/LICENSE-2.0
#
#    Unless required by applicable law or agreed to in writing, software
#    distributed under the License is distributed on an "AS IS" BASIS,
#    WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
#    See the License for the specific language governing permissions and
#    limitations under the License.
#

# This sample uses Kconfig.defaults to set options common for all
# samples. This file should contain only options specific for this sample
# or overrides of default values.

# Enable CHIP
CONFIG_CHIP=y
CONFIG_CHIP_PROJECT_CONFIG="main/include/CHIPProjectConfig.h"
# 32772 == 0x8004 (example light-switch-app)
CONFIG_CHIP_DEVICE_PRODUCT_ID=32772
CONFIG_STD_CPP17=y

# Add support for LEDs and buttons on Nordic development kits
CONFIG_DK_LIBRARY=y

# General networking settings
CONFIG_NET_IF_MCAST_IPV6_ADDR_COUNT=14

# Bluetooth Low Energy configuration
CONFIG_BT_DEVICE_NAME="MatterSwitch"

# Enable system reset on fatal error
CONFIG_RESET_ON_FATAL_ERROR=y

# Suspend devices when the CPU goes into sleep
CONFIG_PM_DEVICE=y

# Disable all debug features
CONFIG_USE_SEGGER_RTT=n
CONFIG_SHELL=n
CONFIG_OPENTHREAD_SHELL=n
CONFIG_CONSOLE=n
CONFIG_UART_CONSOLE=n
CONFIG_SERIAL=n
CONFIG_LOG=n
CONFIG_LOG_MODE_MINIMAL=n
CONFIG_ASSERT_VERBOSE=n
CONFIG_ASSERT_NO_FILE_INFO=y
CONFIG_PRINTK=n
CONFIG_PRINTK_SYNC=n
CONFIG_THREAD_NAME=n
CONFIG_BOOT_BANNER=n

# Enable Factory Data feature
CONFIG_CHIP_FACTORY_DATA=y
CONFIG_CHIP_FACTORY_DATA_BUILD=y

# Enable the Read Client for binding purposes
CONFIG_CHIP_ENABLE_READ_CLIENT=y