| CONFIG_IDF_TARGET="esp32p4" |
| |
| # Flash size and partition |
| CONFIG_ESPTOOLPY_FLASHSIZE_4MB=y |
| CONFIG_PARTITION_TABLE_CUSTOM=y |
| CONFIG_PARTITION_TABLE_CUSTOM_FILENAME="partitions.csv" |
| |
| # Enable BLE Host but use remote controller |
| CONFIG_BT_ENABLED=y |
| CONFIG_BT_NIMBLE_ENABLED=y |
| CONFIG_BT_NIMBLE_TRANSPORT_UART=n |
| CONFIG_ESP_ENABLE_BT=y |
| |
| # Increase main task stack size |
| CONFIG_ESP_MAIN_TASK_STACK_SIZE=4096 |
| |
| # Disable Wi-Fi Soft AP |
| CONFIG_ESP_WIFI_SOFTAP_SUPPORT=n |
| |
| # LwIP |
| CONFIG_LWIP_IPV6_AUTOCONFIG=y |
| CONFIG_LWIP_IPV6_NUM_ADDRESSES=6 |
| |
| # mbedtls |
| CONFIG_MBEDTLS_HKDF_C=y |
| |
| # Matter shell |
| CONFIG_ENABLE_CHIP_SHELL=y |
| |
| # OTA requestor |
| CONFIG_ENABLE_OTA_REQUESTOR=y |
| |
| # Do not deinit BLE after commissioning |
| CONFIG_USE_BLE_ONLY_FOR_COMMISSIONING=n |
| |
| # ESP32-P4 Function EV Board use ESP32C6 as slave device |
| CONFIG_SLAVE_IDF_TARGET_ESP32C6=y |
