drivers/serial: stm32: Fix indentation in STM32_UART_INIT
Looks better this way
Signed-off-by: Erwan Gouriou <erwan.gouriou@linaro.org>
diff --git a/drivers/serial/uart_stm32.c b/drivers/serial/uart_stm32.c
index fa79446..f8d4c13 100644
--- a/drivers/serial/uart_stm32.c
+++ b/drivers/serial/uart_stm32.c
@@ -745,11 +745,11 @@
#define STM32_UART_IRQ_HANDLER(index) \
static void uart_stm32_irq_config_func_##index(const struct device *dev) \
{ \
- IRQ_CONNECT(DT_INST_IRQN(index), \
- DT_INST_IRQ(index, priority), \
+ IRQ_CONNECT(DT_INST_IRQN(index), \
+ DT_INST_IRQ(index, priority), \
uart_stm32_isr, DEVICE_GET(uart_stm32_##index), \
0); \
- irq_enable(DT_INST_IRQN(index)); \
+ irq_enable(DT_INST_IRQN(index)); \
}
#else
#define STM32_UART_IRQ_HANDLER_DECL(index)
@@ -762,21 +762,21 @@
\
static const struct uart_stm32_config uart_stm32_cfg_##index = { \
.uconf = { \
- .base = (uint8_t *)DT_INST_REG_ADDR(index),\
+ .base = (uint8_t *)DT_INST_REG_ADDR(index), \
STM32_UART_IRQ_HANDLER_FUNC(index) \
}, \
- .pclken = { .bus = DT_INST_CLOCKS_CELL(index, bus), \
- .enr = DT_INST_CLOCKS_CELL(index, bits) \
+ .pclken = { .bus = DT_INST_CLOCKS_CELL(index, bus), \
+ .enr = DT_INST_CLOCKS_CELL(index, bits) \
}, \
- .hw_flow_control = DT_INST_PROP(index, hw_flow_control),\
- .parity = DT_INST_PROP(index, parity)\
+ .hw_flow_control = DT_INST_PROP(index, hw_flow_control), \
+ .parity = DT_INST_PROP(index, parity), \
}; \
\
static struct uart_stm32_data uart_stm32_data_##index = { \
- .baud_rate = DT_INST_PROP(index, current_speed) \
+ .baud_rate = DT_INST_PROP(index, current_speed), \
}; \
\
-DEVICE_AND_API_INIT(uart_stm32_##index, DT_INST_LABEL(index),\
+DEVICE_AND_API_INIT(uart_stm32_##index, DT_INST_LABEL(index), \
&uart_stm32_init, \
&uart_stm32_data_##index, &uart_stm32_cfg_##index, \
PRE_KERNEL_1, CONFIG_KERNEL_INIT_PRIORITY_DEVICE, \
