boards: steval_fcu001v1: Use dts for clocks configuration
Convert board to use of device tree for clocks configuration.
Signed-off-by: Alexandre Bourdiol <alexandre.bourdiol@st.com>
diff --git a/boards/arm/steval_fcu001v1/steval_fcu001v1.dts b/boards/arm/steval_fcu001v1/steval_fcu001v1.dts
index 0f5d45f..c6a9c1e 100644
--- a/boards/arm/steval_fcu001v1/steval_fcu001v1.dts
+++ b/boards/arm/steval_fcu001v1/steval_fcu001v1.dts
@@ -38,6 +38,28 @@
};
};
+&clk_hse {
+ clock-frequency = <DT_FREQ_M(16)>;
+ status = "okay";
+};
+
+&pll {
+ div-m = <16>;
+ mul-n = <336>;
+ div-p = <4>;
+ div-q = <7>;
+ clocks = <&clk_hse>;
+ status = "okay";
+};
+
+&rcc {
+ clocks = <&pll>;
+ clock-frequency = <DT_FREQ_M(84)>;
+ ahb-prescaler = <1>;
+ apb1-prescaler = <2>;
+ apb2-prescaler = <1>;
+};
+
&i2c2 {
pinctrl-0 = <&i2c2_sda_pb3 &i2c2_scl_pb10>;
status = "okay";
diff --git a/boards/arm/steval_fcu001v1/steval_fcu001v1_defconfig b/boards/arm/steval_fcu001v1/steval_fcu001v1_defconfig
index 7532d77..be28532 100644
--- a/boards/arm/steval_fcu001v1/steval_fcu001v1_defconfig
+++ b/boards/arm/steval_fcu001v1/steval_fcu001v1_defconfig
@@ -3,9 +3,6 @@
CONFIG_SOC_SERIES_STM32F4X=y
CONFIG_SOC_STM32F401XC=y
-# 84MHz system clock
-CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=84000000
-
# Enable MPU
CONFIG_ARM_MPU=y
@@ -21,23 +18,5 @@
# enable GPIO
CONFIG_GPIO=y
-# clock configuration
+# Enable Clocks
CONFIG_CLOCK_CONTROL=y
-
-# SYSCLK selection
-CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
-
-# use HSE as PLL input
-CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
-CONFIG_CLOCK_STM32_HSE_CLOCK=16000000
-
-# produce 84MHz clock at PLL output
-CONFIG_CLOCK_STM32_PLL_M_DIVISOR=16
-CONFIG_CLOCK_STM32_PLL_N_MULTIPLIER=336
-CONFIG_CLOCK_STM32_PLL_P_DIVISOR=4
-CONFIG_CLOCK_STM32_PLL_Q_DIVISOR=7
-CONFIG_CLOCK_STM32_AHB_PRESCALER=1
-
-# APB1 clock must not exceed 50MHz limit
-CONFIG_CLOCK_STM32_APB1_PRESCALER=2
-CONFIG_CLOCK_STM32_APB2_PRESCALER=1
