| // Copyright 2022 The Pigweed Authors |
| // |
| // Licensed under the Apache License, Version 2.0 (the "License"); you may not |
| // use this file except in compliance with the License. You may obtain a copy of |
| // the License at |
| // |
| // https://www.apache.org/licenses/LICENSE-2.0 |
| // |
| // Unless required by applicable law or agreed to in writing, software |
| // distributed under the License is distributed on an "AS IS" BASIS, WITHOUT |
| // WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the |
| // License for the specific language governing permissions and limitations under |
| // the License. |
| #pragma once |
| |
| #include <cstddef> |
| |
| #include "pw_digital_io/digital_io.h" |
| #include "pw_display_driver/display_driver.h" |
| #include "pw_spi/device.h" |
| |
| namespace pw { |
| namespace display_driver { |
| |
| class DisplayDriverILI9341 : public DisplayDriver { |
| public: |
| // DisplayDriverILI9341 configuration parameters. |
| struct Config { |
| // The GPIO line to use when specifying data/command mode for the display |
| // controller. |
| pw::digital_io::DigitalOut& data_cmd_gpio; |
| // Optional GPIO line to reset the display controller. |
| pw::digital_io::DigitalOut* reset_gpio; |
| // The SPI device to which the display controller is connected. |
| pw::spi::Device& spi_device; |
| }; |
| |
| DisplayDriverILI9341(const Config& config); |
| |
| // DisplayDriver implementation: |
| // The SPI bus must be in 8-bit mode before calling this function. |
| Status Init() override; |
| // The SPI bus must be in 16-bit mode before calling this function. |
| Status Update(pw::framebuffer::FramebufferRgb565* framebuffer); |
| Status UpdatePixelDouble(pw::framebuffer::FramebufferRgb565* frame_buffer); |
| |
| private: |
| enum class Mode { |
| kData, |
| kCommand, |
| }; |
| |
| // A command and optional data to write to the ILI9341. |
| struct Command { |
| uint8_t command; |
| ConstByteSpan command_data; |
| }; |
| |
| // Toggle the reset GPIO line to reset the display controller. |
| Status Reset(); |
| |
| // Set the command/data mode of the display controller. |
| void SetMode(Mode mode); |
| // Write the command to the display controller. |
| Status WriteCommand(pw::spi::Device::Transaction& transaction, |
| const Command& command); |
| |
| pw::digital_io::DigitalOut& data_cmd_gpio_; // Pin to specify D/CX mode. |
| pw::digital_io::DigitalOut* reset_gpio_; // Optional to reset controller. |
| pw::spi::Device& spi_device_; // SPI device connected to controller. |
| }; |
| |
| } // namespace display_driver |
| } // namespace pw |