| # Copyright 2023 The Pigweed Authors |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); you may not |
| # use this file except in compliance with the License. You may obtain a copy of |
| # the License at |
| # |
| # https://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, WITHOUT |
| # WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the |
| # License for the specific language governing permissions and limitations under |
| # the License. |
| |
| declare_args() { |
| # Display width in pixels (ex. "320") |
| pw_app_common_DISPLAY_WIDTH = "0" |
| |
| # Display height in pixels (ex. "240") |
| pw_app_common_DISPLAY_HEIGHT = "0" |
| |
| # Framebuffer width in pixels (ex. "320") |
| # A value of -1 will cause the framebuffer to have the same value as |
| # pw_app_common_DISPLAY_WIDTH |
| pw_app_common_FRAMEBUFFER_WIDTH = "-1" |
| |
| # Framebuffer start pixel X coord (ex. "4") |
| pw_app_common_FRAMEBUFFER_START_X = "0" |
| |
| # Framebuffer start pixel Y coord (ex. "4") |
| pw_app_common_FRAMEBUFFER_START_Y = "0" |
| |
| # Display backlight pin (ex "4", or "-1" if unused) |
| pw_app_common_BACKLIGHT_GPIO = "-1" |
| |
| # Display tear effect output GPIO pin (ex "2", or "-1" if unused) |
| pw_app_common_DISPLAY_TE_GPIO = "-1" |
| |
| # Display reset GPIO pin (ex "2", or "-1" if unused) |
| pw_app_common_DISPLAY_RESET_GPIO = "-1" |
| |
| # GPIO Port of display CS pin (ex. "A") |
| # Only used on STM32 targets. |
| pw_app_common_STM32_DISPLAY_CS_PORT = "" |
| |
| # GPIO Pin of display CS (ex. "10") |
| pw_app_common_DISPLAY_CS_GPIO = "" |
| |
| # GPIO Port of display DC pin (ex. "B") |
| # Only used on STM32 targets. |
| pw_app_common_STM32_DISPLAY_DC_PORT = "" |
| |
| # GPIO Pin of display dc (ex. "11") |
| pw_app_common_DISPLAY_DC_GPIO = "" |
| |
| # SPI bus MISO pin (ex. "12", or "-1" if unusedsable) |
| pw_app_common_SPI_MISO_GPIO = "-1" |
| |
| # SPI bus MOSI pin (ex. "13") |
| pw_app_common_SPI_MOSI_GPIO = "" |
| |
| # SPI bus clock pin (ex. "14") |
| pw_app_common_SPI_CLOCK_GPIO = "" |
| } |