blob: 107dde8da7ab0cdb6984c72c0cf1ccc1ccb60353 [file] [log] [blame]
.. _module-pw_stream_uart_mcuxpresso:
=========================
pw_stream_uart_mcuxpresso
=========================
``pw_stream_uart_mcuxpresso`` implements the ``pw_stream`` interface for reading
and writing to a UART using the NXP MCUXpresso SDK. ``UartStreamMcuxpresso``
version uses the CPU to read and write to the UART, while ``UartDmaStreamMcuxpresso``
uses DMA transfers to read and write to the UART minimizing the CPU utilization.
``InterruptSafeUartWriterMcuxpresso`` implements an interrupt safe
write-only stream to UART. Intended for use in fault handlers. It can be
constructed ``constinit`` for use in pre-static constructor environments as well.
.. note::
This module will likely be superseded by a future ``pw_uart`` interface.
Setup
=====
This module requires a little setup:
1. Use ``pw_build_mcuxpresso`` to create a ``pw_source_set`` for an
MCUXpresso SDK.
2. Include the debug console component in this SDK definition.
3. Specify the ``pw_third_party_mcuxpresso_SDK`` GN global variable to specify
the name of this source set.
4. Use a target that calls ``pw_sys_io_mcuxpresso_Init`` in
``pw_boot_PreMainInit`` or similar.
The name of the SDK source set must be set in the
"pw_third_party_mcuxpresso_SDK" GN arg
Usage
=====
``UartStreamMcuxpresso`` example:
.. literalinclude:: stream_example.cc
:language: cpp
:linenos:
:start-after: [pw_stream_uart_mcuxpresso-UartStreamExample]
:end-before: [pw_stream_uart_mcuxpresso-UartStreamExample]
``UartDmaStreamMcuxpresso`` example:
.. literalinclude:: dma_stream_example.cc
:language: cpp
:linenos:
:start-after: [pw_stream_uart_mcuxpresso-UartDmaStreamExample]
:end-before: [pw_stream_uart_mcuxpresso-UartDmaStreamExample]
``InterruptSafeUartWriterMcuxpresso`` example:
.. literalinclude:: interrupt_safe_writer_example.cc
:language: cpp
:linenos:
:start-after: [pw_stream_uart_mcuxpresso-UartInterruptSafeWriterExample]
:end-before: [pw_stream_uart_mcuxpresso-UartInterruptSafeWriterExample]