| /* | |
| * File: mcf52221demo_sysinit.h | |
| * Purpose: Power-on Reset configuration of the MCF52221. | |
| * | |
| * Notes: | |
| * | |
| */ | |
| #ifndef __MCF52221DEMO_SYSINIT_H__ | |
| #define __MCF52221DEMO_SYSINIT_H__ | |
| #ifdef __cplusplus | |
| extern "C" { | |
| #endif | |
| #if ENABLE_UART_SUPPORT==1 | |
| #define TERMINAL_PORT 0 | |
| #define TERMINAL_BAUD kBaud19200 | |
| #endif /* ENABLE_UART_SUPPORT==1 */ | |
| #define SYSTEM_CLOCK_KHZ 80000 /* system bus frequency in kHz */ | |
| /********************************************************************/ | |
| /* __initialize_hardware Startup code routine | |
| * | |
| * __initialize_hardware is called by the startup code right after reset, | |
| * with interrupt disabled and SP pre-set to a valid memory area. | |
| * Here you should initialize memory and some peripherics; | |
| * at this point global variables are not initialized yet. | |
| * The startup code will initialize SP on return of this function. | |
| */ | |
| void __initialize_hardware(void); | |
| /********************************************************************/ | |
| /* __initialize_system Startup code routine | |
| * | |
| * __initialize_system is called by the startup code when all languages | |
| * specific initialization are done to allow additional hardware setup. | |
| */ | |
| void __initialize_system(void); | |
| #ifdef __cplusplus | |
| } | |
| #endif | |
| #endif /* __MCF52221DEMO_SYSINIT_H__ */ | |