| /* |
| * Copyright (c) 2018 Justin Watson |
| * Copyright (c) 2020 ATL Electronics |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #define DT_DRV_COMPAT cypress_psoc6_gpio |
| |
| #include <errno.h> |
| #include <kernel.h> |
| #include <device.h> |
| #include <init.h> |
| #include <soc.h> |
| #include <drivers/gpio.h> |
| |
| #include "gpio_utils.h" |
| #include "cy_gpio.h" |
| #include "cy_sysint.h" |
| |
| #define LOG_LEVEL CONFIG_GPIO_LOG_LEVEL |
| #include <logging/log.h> |
| LOG_MODULE_REGISTER(gpio_psoc6); |
| |
| typedef void (*config_func_t)(const struct device *dev); |
| |
| struct gpio_psoc6_config { |
| /* gpio_driver_config needs to be first */ |
| struct gpio_driver_config common; |
| GPIO_PRT_Type *regs; |
| config_func_t config_func; |
| }; |
| |
| struct gpio_psoc6_runtime { |
| /* gpio_driver_data needs to be first */ |
| struct gpio_driver_data common; |
| sys_slist_t cb; |
| }; |
| |
| #define DEV_CFG(dev) \ |
| ((const struct gpio_psoc6_config * const)(dev)->config) |
| #define DEV_DATA(dev) \ |
| ((struct gpio_psoc6_runtime * const)(dev)->data) |
| |
| static int gpio_psoc6_config(const struct device *dev, |
| gpio_pin_t pin, |
| gpio_flags_t flags) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| uint32_t drv_mode; |
| uint32_t pin_val; |
| |
| if (flags & GPIO_OUTPUT) { |
| if (flags & GPIO_SINGLE_ENDED) { |
| drv_mode = (flags & GPIO_LINE_OPEN_DRAIN) ? |
| CY_GPIO_DM_OD_DRIVESLOW_IN_OFF : |
| CY_GPIO_DM_OD_DRIVESHIGH_IN_OFF; |
| |
| pin_val = (flags & GPIO_LINE_OPEN_DRAIN) ? 1 : 0; |
| } else { |
| drv_mode = CY_GPIO_DM_STRONG_IN_OFF; |
| |
| pin_val = (flags & GPIO_OUTPUT_INIT_HIGH) ? 1 : 0; |
| } |
| } else { |
| if ((flags & GPIO_PULL_UP) && (flags & GPIO_PULL_DOWN)) { |
| drv_mode = CY_GPIO_DM_PULLUP_DOWN_IN_OFF; |
| } else if (flags & GPIO_PULL_UP) { |
| drv_mode = CY_GPIO_DM_PULLUP_IN_OFF; |
| } else if (flags & GPIO_PULL_DOWN) { |
| drv_mode = CY_GPIO_DM_PULLDOWN_IN_OFF; |
| } else { |
| drv_mode = CY_GPIO_DM_ANALOG; |
| } |
| |
| pin_val = (flags & GPIO_PULL_UP) ? 1 : 0; |
| } |
| |
| if (flags & GPIO_INPUT) { |
| /* enable input buffer */ |
| drv_mode |= CY_GPIO_DM_HIGHZ; |
| } |
| |
| Cy_GPIO_Pin_FastInit(port, pin, drv_mode, pin_val, HSIOM_SEL_GPIO); |
| Cy_GPIO_SetVtrip(port, pin, CY_GPIO_VTRIP_CMOS); |
| Cy_GPIO_SetSlewRate(port, pin, CY_GPIO_SLEW_FAST); |
| Cy_GPIO_SetDriveSel(port, pin, CY_GPIO_DRIVE_FULL); |
| |
| LOG_DBG("P: 0x%08x, Pin: %d, Mode: 0x%08x, Val: 0x%02x", |
| (unsigned int) port, pin, drv_mode, pin_val); |
| |
| return 0; |
| } |
| |
| static int gpio_psoc6_port_get_raw(const struct device *dev, |
| uint32_t *value) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| |
| *value = GPIO_PRT_IN(port); |
| |
| LOG_DBG("P: 0x%08x, V: 0x%08x", (unsigned int) port, *value); |
| |
| return 0; |
| } |
| |
| static int gpio_psoc6_port_set_masked_raw(const struct device *dev, |
| uint32_t mask, |
| uint32_t value) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| |
| GPIO_PRT_OUT(port) = (GPIO_PRT_IN(port) & ~mask) | (mask & value); |
| |
| return 0; |
| } |
| |
| static int gpio_psoc6_port_set_bits_raw(const struct device *dev, |
| uint32_t mask) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| |
| GPIO_PRT_OUT_SET(port) = mask; |
| |
| return 0; |
| } |
| |
| static int gpio_psoc6_port_clear_bits_raw(const struct device *dev, |
| uint32_t mask) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| |
| GPIO_PRT_OUT_CLR(port) = mask; |
| |
| return 0; |
| } |
| |
| static int gpio_psoc6_port_toggle_bits(const struct device *dev, |
| uint32_t mask) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| |
| GPIO_PRT_OUT_INV(port) = mask; |
| |
| return 0; |
| } |
| |
| static int gpio_psoc6_pin_interrupt_configure(const struct device *dev, |
| gpio_pin_t pin, |
| enum gpio_int_mode mode, |
| enum gpio_int_trig trig) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| uint32_t is_enabled = ((mode == GPIO_INT_MODE_DISABLED) ? 0 : 1); |
| uint32_t lv_trg = CY_GPIO_INTR_DISABLE; |
| |
| if (mode == GPIO_INT_MODE_LEVEL) { |
| return -ENOTSUP; |
| } |
| |
| if (is_enabled) { |
| switch (trig) { |
| case GPIO_INT_TRIG_BOTH: |
| lv_trg = CY_GPIO_INTR_BOTH; |
| break; |
| case GPIO_INT_TRIG_HIGH: |
| lv_trg = CY_GPIO_INTR_RISING; |
| break; |
| case GPIO_INT_TRIG_LOW: |
| lv_trg = CY_GPIO_INTR_FALLING; |
| break; |
| } |
| } |
| |
| Cy_GPIO_ClearInterrupt(port, pin); |
| Cy_GPIO_SetInterruptEdge(port, pin, lv_trg); |
| Cy_GPIO_SetInterruptMask(port, pin, is_enabled); |
| /** |
| * The driver will set 50ns glich free filter for any interrupt. |
| */ |
| Cy_GPIO_SetFilter(port, pin); |
| |
| LOG_DBG("config: Pin: %d, Trg: %d", pin, lv_trg); |
| |
| return 0; |
| } |
| |
| static void gpio_psoc6_isr(const struct device *dev) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| struct gpio_psoc6_runtime *context = dev->data; |
| uint32_t int_stat; |
| |
| int_stat = GPIO_PRT_INTR_MASKED(port); |
| |
| /* Any INTR MMIO registers AHB clearing must be preceded with an AHB |
| * read access. Taken from Cy_GPIO_ClearInterrupt() |
| */ |
| (void)GPIO_PRT_INTR(port); |
| GPIO_PRT_INTR(port) = int_stat; |
| /* This read ensures that the initial write has been flushed out to HW |
| */ |
| (void)GPIO_PRT_INTR(port); |
| |
| gpio_fire_callbacks(&context->cb, dev, int_stat); |
| } |
| |
| static int gpio_psoc6_manage_callback(const struct device *port, |
| struct gpio_callback *callback, |
| bool set) |
| { |
| struct gpio_psoc6_runtime *context = port->data; |
| |
| return gpio_manage_callback(&context->cb, callback, set); |
| } |
| |
| static uint32_t gpio_psoc6_get_pending_int(const struct device *dev) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| GPIO_PRT_Type * const port = cfg->regs; |
| |
| LOG_DBG("Pending: 0x%08x", GPIO_PRT_INTR_MASKED(port)); |
| |
| return GPIO_PRT_INTR_MASKED(port); |
| } |
| |
| static const struct gpio_driver_api gpio_psoc6_api = { |
| .pin_configure = gpio_psoc6_config, |
| .port_get_raw = gpio_psoc6_port_get_raw, |
| .port_set_masked_raw = gpio_psoc6_port_set_masked_raw, |
| .port_set_bits_raw = gpio_psoc6_port_set_bits_raw, |
| .port_clear_bits_raw = gpio_psoc6_port_clear_bits_raw, |
| .port_toggle_bits = gpio_psoc6_port_toggle_bits, |
| .pin_interrupt_configure = gpio_psoc6_pin_interrupt_configure, |
| .manage_callback = gpio_psoc6_manage_callback, |
| .get_pending_int = gpio_psoc6_get_pending_int, |
| }; |
| |
| int gpio_psoc6_init(const struct device *dev) |
| { |
| const struct gpio_psoc6_config * const cfg = DEV_CFG(dev); |
| |
| cfg->config_func(dev); |
| |
| return 0; |
| } |
| |
| #define GPIO_PSOC6_INIT(n) \ |
| static void port_##n##_psoc6_config_func(const struct device *dev); \ |
| \ |
| static const struct gpio_psoc6_config port_##n##_psoc6_config = { \ |
| .common = { \ |
| .port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(n),\ |
| }, \ |
| .regs = (GPIO_PRT_Type *)DT_INST_REG_ADDR(n), \ |
| .config_func = port_##n##_psoc6_config_func, \ |
| }; \ |
| \ |
| static struct gpio_psoc6_runtime port_##n##_psoc6_runtime = { 0 }; \ |
| \ |
| DEVICE_DT_INST_DEFINE(n, gpio_psoc6_init, NULL, \ |
| &port_##n##_psoc6_runtime, \ |
| &port_##n##_psoc6_config, POST_KERNEL, \ |
| CONFIG_KERNEL_INIT_PRIORITY_DEVICE, \ |
| &gpio_psoc6_api); \ |
| \ |
| static void port_##n##_psoc6_config_func(const struct device *dev) \ |
| { \ |
| CY_PSOC6_DT_INST_NVIC_INSTALL(n, gpio_psoc6_isr); \ |
| }; |
| |
| DT_INST_FOREACH_STATUS_OKAY(GPIO_PSOC6_INIT) |