| /* |
| * Copyright (c) 2023 Martin Kiepfer |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #define DT_DRV_COMPAT x_powers_axp192_gpio |
| |
| #include <errno.h> |
| |
| #include <zephyr/drivers/gpio.h> |
| #include <zephyr/drivers/gpio/gpio_utils.h> |
| #include <zephyr/drivers/i2c.h> |
| #include <zephyr/kernel.h> |
| #include <zephyr/sys/util_macro.h> |
| #include <zephyr/toolchain.h> |
| #include <zephyr/logging/log.h> |
| #include <zephyr/drivers/mfd/axp192.h> |
| |
| LOG_MODULE_REGISTER(gpio_axp192, CONFIG_GPIO_LOG_LEVEL); |
| |
| struct gpio_axp192_config { |
| struct gpio_driver_config common; |
| struct i2c_dt_spec i2c; |
| const struct device *mfd; |
| uint32_t ngpios; |
| }; |
| |
| struct gpio_axp192_data { |
| struct gpio_driver_data common; |
| struct k_mutex mutex; |
| sys_slist_t cb_list_gpio; |
| }; |
| |
| static int gpio_axp192_port_get_raw(const struct device *dev, uint32_t *value) |
| { |
| int ret; |
| uint8_t port_val; |
| const struct gpio_axp192_config *config = dev->config; |
| |
| if (k_is_in_isr()) { |
| return -EWOULDBLOCK; |
| } |
| |
| ret = mfd_axp192_gpio_read_port(config->mfd, &port_val); |
| if (ret == 0) { |
| *value = port_val; |
| } |
| |
| return ret; |
| } |
| |
| static int gpio_axp192_port_set_masked_raw(const struct device *dev, gpio_port_pins_t mask, |
| gpio_port_value_t value) |
| { |
| int ret; |
| const struct gpio_axp192_config *config = dev->config; |
| |
| if (k_is_in_isr()) { |
| return -EWOULDBLOCK; |
| } |
| |
| ret = mfd_axp192_gpio_write_port(config->mfd, value, mask); |
| |
| return ret; |
| } |
| |
| static int gpio_axp192_port_set_bits_raw(const struct device *dev, gpio_port_pins_t pins) |
| { |
| return gpio_axp192_port_set_masked_raw(dev, pins, pins); |
| } |
| |
| static int gpio_axp192_port_clear_bits_raw(const struct device *dev, gpio_port_pins_t pins) |
| { |
| return gpio_axp192_port_set_masked_raw(dev, pins, 0); |
| } |
| |
| static int gpio_axp192_configure(const struct device *dev, gpio_pin_t pin, gpio_flags_t flags) |
| { |
| const struct gpio_axp192_config *config = dev->config; |
| int ret; |
| enum axp192_gpio_func func; |
| |
| if (pin >= config->ngpios) { |
| LOG_ERR("Invalid gpio pin (%d)", pin); |
| return -EINVAL; |
| } |
| |
| if (k_is_in_isr()) { |
| return -EWOULDBLOCK; |
| } |
| |
| /* Configure pin */ |
| LOG_DBG("Pin: %d / flags=0x%x", pin, flags); |
| if ((flags & GPIO_OUTPUT) != 0) { |
| |
| /* Initialize output function */ |
| func = AXP192_GPIO_FUNC_OUTPUT_LOW; |
| if ((flags & GPIO_OPEN_DRAIN) != 0) { |
| func = AXP192_GPIO_FUNC_OUTPUT_OD; |
| } |
| ret = mfd_axp192_gpio_func_ctrl(config->mfd, dev, pin, func); |
| if (ret != 0) { |
| return ret; |
| } |
| |
| /* Set init value */ |
| if ((flags & GPIO_OUTPUT_INIT_LOW) != 0) { |
| ret = mfd_axp192_gpio_write_port(config->mfd, BIT(pin), 0); |
| } else if ((flags & GPIO_OUTPUT_INIT_HIGH) != 0) { |
| ret = mfd_axp192_gpio_write_port(config->mfd, BIT(pin), BIT(pin)); |
| } |
| } else if ((flags & GPIO_INPUT) != 0) { |
| |
| /* Initialize input function */ |
| func = AXP192_GPIO_FUNC_INPUT; |
| |
| ret = mfd_axp192_gpio_func_ctrl(config->mfd, dev, pin, func); |
| if (ret != 0) { |
| return ret; |
| } |
| |
| /* Configure pull-down */ |
| if ((flags & GPIO_PULL_UP) != 0) { |
| /* not supported */ |
| LOG_ERR("Pull-Up not supported"); |
| ret = -ENOTSUP; |
| } else if ((flags & GPIO_PULL_DOWN) != 0) { |
| /* out = 0 means pull-down*/ |
| ret = mfd_axp192_gpio_pd_ctrl(config->mfd, pin, true); |
| } else { |
| ret = mfd_axp192_gpio_pd_ctrl(config->mfd, pin, false); |
| } |
| } else { |
| /* Neither input nor output mode is selected */ |
| LOG_INF("No valid gpio mode selected"); |
| ret = -ENOTSUP; |
| } |
| |
| return ret; |
| } |
| |
| static int gpio_axp192_port_toggle_bits(const struct device *dev, gpio_port_pins_t pins) |
| { |
| struct gpio_axp192_data *data = dev->data; |
| int ret; |
| uint32_t value; |
| |
| k_mutex_lock(&data->mutex, K_FOREVER); |
| |
| ret = gpio_axp192_port_get_raw(dev, &value); |
| if (ret == 0) { |
| ret = gpio_axp192_port_set_masked_raw(dev, pins, ~value); |
| } |
| |
| k_mutex_unlock(&data->mutex); |
| |
| return ret; |
| } |
| |
| static int gpio_axp192_pin_interrupt_configure(const struct device *dev, gpio_pin_t pin, |
| enum gpio_int_mode mode, enum gpio_int_trig trig) |
| { |
| ARG_UNUSED(dev); |
| ARG_UNUSED(pin); |
| ARG_UNUSED(mode); |
| ARG_UNUSED(trig); |
| |
| return -ENOTSUP; |
| } |
| |
| #if defined(CONFIG_GPIO_GET_CONFIG) || defined(CONFIG_GPIO_GET_DIRECTION) |
| static int gpio_axp192_get_config(const struct device *dev, gpio_pin_t pin, gpio_flags_t *out_flags) |
| { |
| const struct gpio_axp192_config *config = dev->config; |
| enum axp192_gpio_func func; |
| bool pd_enabled; |
| int ret; |
| |
| if (k_is_in_isr()) { |
| return -EWOULDBLOCK; |
| } |
| |
| ret = mfd_axp192_gpio_func_get(config->mfd, pin, &func); |
| if (ret != 0) { |
| return ret; |
| } |
| |
| /* Set OUTPUT/INPUT flags */ |
| *out_flags = 0; |
| switch (func) { |
| case AXP192_GPIO_FUNC_INPUT: |
| *out_flags |= GPIO_INPUT; |
| break; |
| case AXP192_GPIO_FUNC_OUTPUT_OD: |
| *out_flags |= GPIO_OUTPUT | GPIO_OPEN_DRAIN; |
| break; |
| case AXP192_GPIO_FUNC_OUTPUT_LOW: |
| *out_flags |= GPIO_OUTPUT; |
| break; |
| |
| case AXP192_GPIO_FUNC_LDO: |
| __fallthrough; |
| case AXP192_GPIO_FUNC_ADC: |
| __fallthrough; |
| case AXP192_GPIO_FUNC_FLOAT: |
| __fallthrough; |
| default: |
| LOG_DBG("Pin %d not configured as GPIO", pin); |
| break; |
| } |
| |
| /* Query pull-down config statusĀ */ |
| ret = mfd_axp192_gpio_pd_get(config->mfd, pin, &pd_enabled); |
| if (ret != 0) { |
| return ret; |
| } |
| |
| if (pd_enabled) { |
| *out_flags |= GPIO_PULL_DOWN; |
| } |
| |
| return 0; |
| } |
| #endif /* CONFIG_GPIO_GET_CONFIG */ |
| |
| #ifdef CONFIG_GPIO_GET_DIRECTION |
| static int gpio_axp192_port_get_direction(const struct device *dev, gpio_port_pins_t map, |
| gpio_port_pins_t *inputs, gpio_port_pins_t *outputs) |
| { |
| const struct gpio_axp192_config *config = dev->config; |
| gpio_flags_t flags; |
| int ret; |
| |
| /* reset output variables */ |
| *inputs = 0; |
| *outputs = 0; |
| |
| /* loop through all */ |
| for (gpio_pin_t gpio = 0; gpio < config->ngpios; gpio++) { |
| |
| if ((map & (1u << gpio)) != 0) { |
| |
| /* use internal get_config method to get gpio flags */ |
| ret = gpio_axp192_get_config(dev, gpio, &flags); |
| if (ret != 0) { |
| return ret; |
| } |
| |
| /* Set output and input flags */ |
| if ((flags & GPIO_OUTPUT) != 0) { |
| *outputs |= (1u << gpio); |
| } else if (0 != (flags & GPIO_INPUT)) { |
| *inputs |= (1u << gpio); |
| } |
| } |
| } |
| |
| return 0; |
| } |
| #endif /* CONFIG_GPIO_GET_DIRECTION */ |
| |
| static int gpio_axp192_manage_callback(const struct device *dev, struct gpio_callback *callback, |
| bool set) |
| { |
| struct gpio_axp192_data *const data = dev->data; |
| |
| return gpio_manage_callback(&data->cb_list_gpio, callback, set); |
| } |
| |
| static const struct gpio_driver_api gpio_axp192_api = { |
| .pin_configure = gpio_axp192_configure, |
| .port_get_raw = gpio_axp192_port_get_raw, |
| .port_set_masked_raw = gpio_axp192_port_set_masked_raw, |
| .port_set_bits_raw = gpio_axp192_port_set_bits_raw, |
| .port_clear_bits_raw = gpio_axp192_port_clear_bits_raw, |
| .port_toggle_bits = gpio_axp192_port_toggle_bits, |
| .pin_interrupt_configure = gpio_axp192_pin_interrupt_configure, |
| .manage_callback = gpio_axp192_manage_callback, |
| #ifdef CONFIG_GPIO_GET_DIRECTION |
| .port_get_direction = gpio_axp192_port_get_direction, |
| #endif /* CONFIG_GPIO_GET_DIRECTION */ |
| #ifdef CONFIG_GPIO_GET_CONFIG |
| .pin_get_config = gpio_axp192_get_config, |
| #endif |
| }; |
| |
| static int gpio_axp192_init(const struct device *dev) |
| { |
| const struct gpio_axp192_config *config = dev->config; |
| struct gpio_axp192_data *data = dev->data; |
| |
| LOG_DBG("Initializing"); |
| |
| if (!i2c_is_ready_dt(&config->i2c)) { |
| LOG_ERR("device not ready"); |
| return -ENODEV; |
| } |
| |
| return k_mutex_init(&data->mutex); |
| } |
| |
| #define GPIO_AXP192_DEFINE(inst) \ |
| static const struct gpio_axp192_config gpio_axp192_config##inst = { \ |
| .common = \ |
| { \ |
| .port_pin_mask = GPIO_PORT_PIN_MASK_FROM_DT_INST(inst), \ |
| }, \ |
| .i2c = I2C_DT_SPEC_GET(DT_INST_PARENT(inst)), \ |
| .mfd = DEVICE_DT_GET(DT_INST_PARENT(inst)), \ |
| .ngpios = DT_INST_PROP(inst, ngpios), \ |
| }; \ |
| \ |
| static struct gpio_axp192_data gpio_axp192_data##inst; \ |
| \ |
| DEVICE_DT_INST_DEFINE(inst, gpio_axp192_init, NULL, &gpio_axp192_data##inst, \ |
| &gpio_axp192_config##inst, POST_KERNEL, \ |
| CONFIG_GPIO_AXP192_INIT_PRIORITY, &gpio_axp192_api); |
| |
| DT_INST_FOREACH_STATUS_OKAY(GPIO_AXP192_DEFINE) |