boards/kws/pico2_spe/pico2_spe.dtsi

/*
 * Copyright (c) 2025 KWS Computersysteme Gmbh
 *
 * SPDX-License-Identifier: Apache-2.0
 */

#include <freq.h>
#include <zephyr/dt-bindings/i2c/i2c.h>
#include <zephyr/dt-bindings/pwm/pwm.h>

#include "pico2_spe-pinctrl.dtsi"

/ {
	chosen {
		zephyr,sram = &sram0;
		zephyr,flash = &flash0;
		zephyr,console = &uart0;
		zephyr,shell-uart = &uart0;
		zephyr,code-partition = &code_partition;
	};

	aliases {
		watchdog0 = &wdt0;
	};

	pico_header: connector {
		compatible = "raspberrypi,pico-header";
		#gpio-cells = <2>;
		gpio-map-mask = <0xffffffff 0xffffffc0>;
		gpio-map-pass-thru = <0 0x3f>;
		gpio-map = <0 0 &gpio0 0 0>,	/* GP0 */
			<1 0 &gpio0 1 0>,	/* GP1 */
			<2 0 &gpio0 2 0>,	/* GP2 */
			<3 0 &gpio0 3 0>,	/* GP3 */
			<4 0 &gpio0 4 0>,	/* GP4 */
			<5 0 &gpio0 5 0>,	/* GP5 */
			<6 0 &gpio0 6 0>,	/* GP6 */
			<7 0 &gpio0 7 0>,	/* GP7 */
			<8 0 &gpio0 8 0>,	/* GP8 */
			<9 0 &gpio0 9 0>,	/* GP9 */
			<10 0 &gpio0 10 0>,	/* GP10 */
			<11 0 &gpio0 11 0>,	/* GP11 */
			<12 0 &gpio0 12 0>,	/* GP12 */
			<13 0 &gpio0 13 0>,	/* GP13 */
			<14 0 &gpio0 14 0>,	/* GP14 */
			<15 0 &gpio0 15 0>,	/* GP15 */
			<16 0 &gpio0 16 0>,	/* GP16 */
			<17 0 &gpio0 17 0>,	/* GP17 */
			<18 0 &gpio0 18 0>,	/* GP18 */
			<19 0 &gpio0 19 0>,	/* GP19 */
			<20 0 &gpio0 20 0>,	/* GP20 */
			<21 0 &gpio0 21 0>,	/* GP21 */
			<22 0 &gpio0 22 0>,	/* GP22 */
			<26 0 &gpio0 26 0>,	/* GP26 */
			<27 0 &gpio0 27 0>,	/* GP27 */
			<28 0 &gpio0 28 0>;	/* GP28 */
	};
};

&flash0 {
	reg = <0x10000000 DT_SIZE_M(4)>;

	partitions {
		compatible = "fixed-partitions";
		#address-cells = <1>;
		#size-cells = <1>;

		/* Reserved memory for an image definition block. The block is much
		 * smaller than 256 bytes, but in practice the linker places the vector
		 * table at a much larger alignment offset.
		 */
		image_def: partition@0 {
			label = "image_def";
			reg = <0x00000000 0x100>;
			read-only;
		};

		/*
		 * Usable flash. Starts at 0x100, after the image definition block.
		 * The partition size is 4MB minus the 0x100 bytes taken by the
		 * image definition.
		 */
		code_partition: partition@100 {
			label = "code-partition";
			reg = <0x100 (DT_SIZE_M(4) - 0x100)>;
			read-only;
		};
	};
};

&uart0 {
	current-speed = <115200>;
	status = "okay";
	pinctrl-0 = <&uart0_default>;
	pinctrl-names = "default";
};

&gpio0 {
	status = "okay";
};

&spi1 {
	clock-frequency = <DT_FREQ_M(25)>;
	status = "okay";
	pinctrl-0 = <&spi1_default>;
		pinctrl-names = "default";
	cs-gpios = <&pico_header 13 GPIO_ACTIVE_LOW>;

	lan8651: lan865x@0 {
		compatible = "microchip,lan865x";
		reg = <0x0>;
		spi-max-frequency = <DT_FREQ_M(25)>;
		int-gpios = <&gpio0 21 (GPIO_ACTIVE_LOW)>;
		rst-gpios = <&gpio0 20 GPIO_ACTIVE_LOW>;
		status = "okay";

		local-mac-address = [ CA 2F B7 10 23 79];

		lan865x_mdio: lan865x_mdio {
			compatible = "microchip,lan865x-mdio";
			status = "okay";
			#address-cells = <1>;
			#size-cells = <0>;
			ethernet-phy@0 {
				compatible = "microchip,t1s-phy";
				reg = <0x0>;
				plca-enable;
				plca-node-id = <0>;
				plca-node-count = <8>;
				plca-burst-count = <0>;
				plca-burst-timer = <0x80>;
				plca-to-timer = <0x20>;
				status = "okay";
			};
		};
	};
};

&i2c0 {
	clock-frequency = <I2C_BITRATE_STANDARD>;
	pinctrl-0 = <&i2c0_default>;
	pinctrl-names = "default";
	status = "okay";
};

&i2c1 {
	clock-frequency = <I2C_BITRATE_STANDARD>;
	pinctrl-0 = <&i2c1_default>;
	pinctrl-names = "default";
	status = "okay";
};

&adc {
	pinctrl-0 = <&adc_default>;
	pinctrl-names = "default";
	status = "okay";
};

&pwm {
	pinctrl-0 = <&pwm_ch4b_default>;
	pinctrl-names = "default";
	divider-int-0 = <255>;
};

&timer0 {
	status = "okay";
};

zephyr_udc0: &usbd {
	status = "okay";
};

pico_serial: &uart0 {};