| /* |
| * Copyright (c) 2016 Intel Corporation. |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #include <errno.h> |
| |
| #include <device.h> |
| #include <i2c.h> |
| #include <ioapic.h> |
| #include <power.h> |
| |
| #include "qm_i2c.h" |
| #include "qm_isr.h" |
| #include "clk.h" |
| #include "soc.h" |
| |
| /* Convenient macros to get the controller instance and the driver data. */ |
| #define GET_CONTROLLER_INSTANCE(dev) \ |
| (((const struct i2c_qmsi_config_info *) \ |
| dev->config->config_info)->instance) |
| #define GET_DRIVER_DATA(dev) \ |
| ((struct i2c_qmsi_driver_data *)dev->driver_data) |
| |
| struct i2c_qmsi_config_info { |
| qm_i2c_t instance; /* Controller instance. */ |
| u32_t default_cfg; |
| clk_periph_t clock_gate; |
| }; |
| |
| static int i2c_qmsi_init(struct device *dev); |
| |
| struct i2c_qmsi_driver_data { |
| struct k_sem device_sync_sem; |
| int transfer_status; |
| struct k_sem sem; |
| #ifdef CONFIG_DEVICE_POWER_MANAGEMENT |
| u32_t device_power_state; |
| qm_i2c_context_t i2c_ctx; |
| #endif |
| }; |
| |
| #ifdef CONFIG_DEVICE_POWER_MANAGEMENT |
| static void i2c_qmsi_set_power_state(struct device *dev, u32_t power_state) |
| { |
| struct i2c_qmsi_driver_data *drv_data = dev->driver_data; |
| |
| drv_data->device_power_state = power_state; |
| } |
| |
| static u32_t i2c_qmsi_get_power_state(struct device *dev) |
| { |
| struct i2c_qmsi_driver_data *drv_data = dev->driver_data; |
| |
| return drv_data->device_power_state; |
| } |
| |
| static int i2c_suspend_device(struct device *dev) |
| { |
| if (device_busy_check(dev)) { |
| return -EBUSY; |
| } |
| |
| struct i2c_qmsi_driver_data *drv_data = GET_DRIVER_DATA(dev); |
| |
| qm_i2c_save_context(GET_CONTROLLER_INSTANCE(dev), &drv_data->i2c_ctx); |
| |
| i2c_qmsi_set_power_state(dev, DEVICE_PM_SUSPEND_STATE); |
| |
| return 0; |
| } |
| |
| static int i2c_resume_device_from_suspend(struct device *dev) |
| { |
| struct i2c_qmsi_driver_data *drv_data = GET_DRIVER_DATA(dev); |
| |
| qm_i2c_restore_context(GET_CONTROLLER_INSTANCE(dev), |
| &drv_data->i2c_ctx); |
| |
| i2c_qmsi_set_power_state(dev, DEVICE_PM_ACTIVE_STATE); |
| |
| return 0; |
| } |
| |
| /* |
| * Implements the driver control management functionality |
| * the *context may include IN data or/and OUT data |
| */ |
| static int i2c_device_ctrl(struct device *dev, u32_t ctrl_command, |
| void *context) |
| { |
| if (ctrl_command == DEVICE_PM_SET_POWER_STATE) { |
| if (*((u32_t *)context) == DEVICE_PM_SUSPEND_STATE) { |
| return i2c_suspend_device(dev); |
| } else if (*((u32_t *)context) == DEVICE_PM_ACTIVE_STATE) { |
| return i2c_resume_device_from_suspend(dev); |
| } |
| } else if (ctrl_command == DEVICE_PM_GET_POWER_STATE) { |
| *((u32_t *)context) = i2c_qmsi_get_power_state(dev); |
| return 0; |
| } |
| |
| return 0; |
| } |
| #else |
| #define i2c_qmsi_set_power_state(...) |
| #endif /* CONFIG_DEVICE_POWER_MANAGEMENT */ |
| |
| #ifdef CONFIG_I2C_0 |
| |
| static struct i2c_qmsi_driver_data driver_data_0; |
| |
| static const struct i2c_qmsi_config_info config_info_0 = { |
| .instance = QM_I2C_0, |
| .default_cfg = CONFIG_I2C_0_DEFAULT_CFG, |
| .clock_gate = CLK_PERIPH_I2C_M0_REGISTER | CLK_PERIPH_CLK, |
| }; |
| |
| DEVICE_DEFINE(i2c_0, CONFIG_I2C_0_NAME, &i2c_qmsi_init, |
| i2c_device_ctrl, &driver_data_0, &config_info_0, POST_KERNEL, |
| CONFIG_KERNEL_INIT_PRIORITY_DEVICE, NULL); |
| |
| #endif /* CONFIG_I2C_0 */ |
| |
| #ifdef CONFIG_I2C_1 |
| |
| static struct i2c_qmsi_driver_data driver_data_1; |
| |
| static const struct i2c_qmsi_config_info config_info_1 = { |
| .instance = QM_I2C_1, |
| .default_cfg = CONFIG_I2C_1_DEFAULT_CFG, |
| .clock_gate = CLK_PERIPH_I2C_M1_REGISTER | CLK_PERIPH_CLK, |
| }; |
| |
| DEVICE_DEFINE(i2c_1, CONFIG_I2C_1_NAME, &i2c_qmsi_init, |
| i2c_device_ctrl, &driver_data_1, &config_info_1, POST_KERNEL, |
| CONFIG_KERNEL_INIT_PRIORITY_DEVICE, NULL); |
| |
| #endif /* CONFIG_I2C_1 */ |
| |
| static int i2c_qmsi_configure(struct device *dev, u32_t config) |
| { |
| qm_i2c_t instance = GET_CONTROLLER_INSTANCE(dev); |
| struct i2c_qmsi_driver_data *driver_data = GET_DRIVER_DATA(dev); |
| qm_i2c_reg_t *const controller = QM_I2C[instance]; |
| int rc; |
| qm_i2c_config_t qm_cfg; |
| |
| /* This driver only supports master mode. */ |
| if (!(I2C_MODE_MASTER & config)) |
| return -EINVAL; |
| |
| qm_cfg.mode = QM_I2C_MASTER; |
| if (I2C_ADDR_10_BITS & config) { |
| qm_cfg.address_mode = QM_I2C_10_BIT; |
| } else { |
| qm_cfg.address_mode = QM_I2C_7_BIT; |
| } |
| |
| switch (I2C_SPEED_GET(config)) { |
| case I2C_SPEED_STANDARD: |
| qm_cfg.speed = QM_I2C_SPEED_STD; |
| break; |
| case I2C_SPEED_FAST: |
| qm_cfg.speed = QM_I2C_SPEED_FAST; |
| break; |
| case I2C_SPEED_FAST_PLUS: |
| qm_cfg.speed = QM_I2C_SPEED_FAST_PLUS; |
| break; |
| default: |
| return -EINVAL; |
| } |
| |
| k_sem_take(&driver_data->sem, K_FOREVER); |
| rc = qm_i2c_set_config(instance, &qm_cfg); |
| k_sem_give(&driver_data->sem); |
| |
| controller->ic_sda_hold = (CONFIG_I2C_SDA_RX_HOLD << 16) + |
| CONFIG_I2C_SDA_TX_HOLD; |
| |
| controller->ic_sda_setup = CONFIG_I2C_SDA_SETUP; |
| |
| return rc; |
| } |
| |
| static void transfer_complete(void *data, int rc, qm_i2c_status_t status, |
| u32_t len) |
| { |
| struct device *dev = (struct device *) data; |
| struct i2c_qmsi_driver_data *driver_data; |
| |
| driver_data = GET_DRIVER_DATA(dev); |
| driver_data->transfer_status = rc; |
| k_sem_give(&driver_data->device_sync_sem); |
| } |
| |
| static int i2c_qmsi_transfer(struct device *dev, struct i2c_msg *msgs, |
| u8_t num_msgs, u16_t addr) |
| { |
| struct i2c_qmsi_driver_data *driver_data = GET_DRIVER_DATA(dev); |
| qm_i2c_t instance = GET_CONTROLLER_INSTANCE(dev); |
| int rc; |
| |
| __ASSERT_NO_MSG(msgs); |
| if (!num_msgs) { |
| return 0; |
| } |
| |
| device_busy_set(dev); |
| |
| for (int i = 0; i < num_msgs; i++) { |
| u8_t op = msgs[i].flags & I2C_MSG_RW_MASK; |
| bool stop = (msgs[i].flags & I2C_MSG_STOP) == I2C_MSG_STOP; |
| qm_i2c_transfer_t xfer = { 0 }; |
| if (op == I2C_MSG_WRITE) { |
| xfer.tx = msgs[i].buf; |
| xfer.tx_len = msgs[i].len; |
| } else { |
| xfer.rx = msgs[i].buf; |
| xfer.rx_len = msgs[i].len; |
| } |
| |
| xfer.callback = transfer_complete; |
| xfer.callback_data = dev; |
| xfer.stop = stop; |
| |
| k_sem_take(&driver_data->sem, K_FOREVER); |
| rc = qm_i2c_master_irq_transfer(instance, &xfer, addr); |
| k_sem_give(&driver_data->sem); |
| |
| if (rc != 0) { |
| device_busy_clear(dev); |
| return -EIO; |
| } |
| |
| /* Block current thread until the I2C transfer completes. */ |
| k_sem_take(&driver_data->device_sync_sem, K_FOREVER); |
| |
| if (driver_data->transfer_status != 0) { |
| device_busy_clear(dev); |
| return -EIO; |
| } |
| } |
| |
| device_busy_clear(dev); |
| |
| return 0; |
| } |
| |
| static const struct i2c_driver_api api = { |
| .configure = i2c_qmsi_configure, |
| .transfer = i2c_qmsi_transfer, |
| }; |
| |
| static int i2c_qmsi_init(struct device *dev) |
| { |
| struct i2c_qmsi_driver_data *driver_data = GET_DRIVER_DATA(dev); |
| const struct i2c_qmsi_config_info *config = dev->config->config_info; |
| qm_i2c_t instance = GET_CONTROLLER_INSTANCE(dev); |
| int err; |
| |
| k_sem_init(&driver_data->device_sync_sem, 0, UINT_MAX); |
| k_sem_init(&driver_data->sem, 1, UINT_MAX); |
| |
| switch (instance) { |
| case QM_I2C_0: |
| /* Register interrupt handler, unmask IRQ and route it |
| * to Lakemont core. |
| */ |
| IRQ_CONNECT(IRQ_GET_NUMBER(QM_IRQ_I2C_0_INT), |
| CONFIG_I2C_0_IRQ_PRI, qm_i2c_0_irq_isr, NULL, |
| (IOAPIC_LEVEL | IOAPIC_HIGH)); |
| irq_enable(IRQ_GET_NUMBER(QM_IRQ_I2C_0_INT)); |
| QM_IR_UNMASK_INTERRUPTS( |
| QM_INTERRUPT_ROUTER->i2c_master_0_int_mask); |
| break; |
| |
| #ifdef CONFIG_I2C_1 |
| case QM_I2C_1: |
| IRQ_CONNECT(IRQ_GET_NUMBER(QM_IRQ_I2C_1_INT), |
| CONFIG_I2C_1_IRQ_PRI, qm_i2c_1_irq_isr, NULL, |
| (IOAPIC_LEVEL | IOAPIC_HIGH)); |
| irq_enable(IRQ_GET_NUMBER(QM_IRQ_I2C_1_INT)); |
| QM_IR_UNMASK_INTERRUPTS( |
| QM_INTERRUPT_ROUTER->i2c_master_1_int_mask); |
| break; |
| #endif /* CONFIG_I2C_1 */ |
| |
| default: |
| return -EIO; |
| } |
| |
| clk_periph_enable(config->clock_gate); |
| |
| err = i2c_qmsi_configure(dev, config->default_cfg); |
| if (err < 0) { |
| return err; |
| } |
| |
| dev->driver_api = &api; |
| |
| i2c_qmsi_set_power_state(dev, DEVICE_PM_ACTIVE_STATE); |
| |
| return 0; |
| } |