| /* |
| * Copyright (c) 2019 Nordic Semiconductor ASA |
| * Copyright (c) 2020 Linaro Ltd. |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #include <stdio.h> |
| #include <zephyr/kernel.h> |
| #include <zephyr/init.h> |
| #include <zephyr/device.h> |
| #include <zephyr/drivers/gpio.h> |
| #include <zephyr/sys/poweroff.h> |
| |
| #include <driverlib/ioc.h> |
| |
| static const struct gpio_dt_spec sw0_gpio = GPIO_DT_SPEC_GET(DT_ALIAS(sw0), gpios); |
| |
| #define BUSY_WAIT_S 5U |
| #define SLEEP_US 2000U |
| #define SLEEP_S 3U |
| |
| extern void CC1352R1_LAUNCHXL_shutDownExtFlash(void); |
| |
| int main(void) |
| { |
| uint32_t config, status; |
| |
| printk("\n%s system off demo\n", CONFIG_BOARD); |
| |
| /* Shut off external flash to save power */ |
| CC1352R1_LAUNCHXL_shutDownExtFlash(); |
| |
| /* Configure to generate PORT event (wakeup) on button 1 press. */ |
| if (!gpio_is_ready_dt(&sw0_gpio)) { |
| printk("%s: device not ready.\n", sw0_gpio.port->name); |
| return 0; |
| } |
| |
| gpio_pin_configure_dt(&sw0_gpio, GPIO_INPUT); |
| |
| /* Set wakeup bits for button gpio */ |
| config = IOCPortConfigureGet(sw0_gpio.pin); |
| config |= IOC_WAKE_ON_LOW; |
| IOCPortConfigureSet(sw0_gpio.pin, IOC_PORT_GPIO, config); |
| |
| printk("Busy-wait %u s\n", BUSY_WAIT_S); |
| k_busy_wait(BUSY_WAIT_S * USEC_PER_SEC); |
| |
| printk("Sleep %u us (IDLE)\n", SLEEP_US); |
| k_usleep(SLEEP_US); |
| |
| printk("Sleep %u s (STANDBY)\n", SLEEP_S); |
| k_sleep(K_SECONDS(SLEEP_S)); |
| |
| printk("Powering off; press BUTTON1 to restart\n"); |
| |
| /* Clear GPIO interrupt */ |
| status = GPIO_getEventMultiDio(GPIO_DIO_ALL_MASK); |
| GPIO_clearEventMultiDio(status); |
| |
| sys_poweroff(); |
| |
| return 0; |
| } |