| .. _ble_mesh_provisioner: |
| |
| Bluetooth: Mesh Provisioner |
| ########################### |
| |
| Overview |
| ******** |
| |
| This sample demonstrates how to use the Bluetooth Mesh APIs related to |
| provisioning and using the Configuration Database (CDB). It is intended |
| to be tested together with a device capable of being provisioned. For |
| example, one could use the sample in |
| :zephyr_file:`samples/bluetooth/mesh` |
| or :zephyr_file:`tests/bluetooth/mesh_shell`. |
| |
| The application provisions itself and loads the CDB with an application |
| key, then waits to receive an Unprovisioned Beacon from a device. If the |
| board has a push button connected via GPIO and configured using the |
| ``sw0`` :ref:`devicetree <dt-guide>` alias, the application then waits |
| for the user to press the button, which will trigger provisioning using |
| PB-ADV. If the board doesn't have the push button, the sample will |
| provision detected devices automatically. Once provisioning is done, the |
| node will be present in the CDB but not yet marked as configured. The |
| application will notice the unconfigured node and start configuring it. |
| If no errors are encountered, the node is marked as configured. |
| |
| The configuration of a node involves adding an application key, getting |
| the composition data, and binding all its models to the application key. |
| |
| Requirements |
| ************ |
| |
| * A board with Bluetooth LE support, or |
| * QEMU with BlueZ running on the host |
| |
| Building and Running |
| ******************** |
| |
| This sample can be found under |
| :zephyr_file:`samples/bluetooth/mesh_provisioner` in the Zephyr tree. |
| |
| See :ref:`bluetooth samples section <bluetooth-samples>` for details on |
| how to run the sample inside QEMU. |
| |
| For other boards, build and flash the application as follows: |
| |
| .. zephyr-app-commands:: |
| :zephyr-app: samples/bluetooth/mesh_provisioner |
| :board: <board> |
| :goals: flash |
| :compact: |
| |
| Refer to your :ref:`board's documentation <boards>` for alternative |
| flash instructions if your board doesn't support the ``flash`` target. |
| |
| To run the application on an :ref:`nrf5340dk_nrf5340`, a Bluetooth controller application |
| must also run on the network core. The :ref:`bluetooth-hci-ipc-sample` sample |
| application may be used. Build this sample with configuration |
| :zephyr_file:`samples/bluetooth/hci_ipc/nrf5340_cpunet_bt_mesh-bt_ll_sw_split.conf` |
| to enable mesh support. |
