| # Kconfig - USB device configuration options |
| |
| # |
| # Copyright (c) 2016 Wind River Systems, Inc. |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| # |
| |
| if USB |
| |
| config USB_DEVICE_DRIVER |
| bool |
| default n |
| |
| config USB_DW |
| bool |
| prompt "Designware USB Device Controller Driver" |
| select USB_DEVICE_DRIVER |
| default n |
| help |
| Designware USB Device Controller Driver. |
| |
| config USB_DW_IRQ_PRI |
| int "DesignWare USB Driver Interrupt priority" |
| depends on USB_DW |
| help |
| USB interrupt priority. |
| |
| config USB_DC_STM32 |
| bool |
| prompt "USB device controller driver for STM32 devices" |
| depends on SOC_FAMILY_STM32 |
| select USB_DEVICE_DRIVER |
| select USE_STM32_LL_USB if !SOC_SERIES_STM32F0X && !SOC_SERIES_STM32F3X && !SOC_SERIES_STM32L0X |
| select USE_STM32_HAL_PCD |
| select USE_STM32_HAL_PCD_EX |
| select HAS_DTS_USB |
| default n |
| help |
| Enable USB support on the STM32 F0, F1, F3, F4, L0 and L4 family of |
| processors. |
| |
| config USB_DC_SAM0 |
| bool |
| prompt "SAM0 series USB Device Controller driver" |
| depends on SOC_FAMILY_SAM0 |
| select USB_DEVICE_DRIVER |
| default n |
| help |
| SAM0 family USB device controller Driver. |
| |
| config USB_NRF52840 |
| bool |
| prompt "Nordic Semiconductor nRF52840 USB Device Controller Driver" |
| depends on SOC_NRF52840 |
| select USB_DEVICE_DRIVER |
| select HAS_DTS_USB |
| default n |
| help |
| nRF52840 USB Device Controller Driver |
| |
| config USB_KINETIS |
| bool |
| prompt "Kinetis USB Device Controller Driver" |
| select USB_DEVICE_DRIVER |
| default n |
| help |
| Kinetis USB Device Controller Driver. |
| |
| config SYS_LOG_USB_DRIVER_LEVEL |
| int |
| prompt "USB driver log level" |
| depends on SYS_LOG |
| default 0 |
| help |
| Sets log level for USB driver |
| |
| Levels are: |
| |
| - 0 OFF, do not write |
| |
| - 1 ERROR, only write SYS_LOG_ERR |
| |
| - 2 WARNING, write SYS_LOG_WRN in addition to previous level |
| |
| - 3 INFO, write SYS_LOG_INF in addition to previous levels |
| |
| - 4 DEBUG, write SYS_LOG_DBG in addition to previous levels |
| |
| config USB_DC_STM32_DISCONN_ENABLE |
| bool |
| depends on USB_DC_STM32 |
| default n |
| help |
| Say Y if your board uses USB DISCONNECT pin to enable the |
| pull-up resistor on USB DP. |
| |
| endif # USB |
