blob: abf57a46a11be60b633e40aaa10c55fd1e8332fe [file] [log] [blame]
# nRF9160 innblue V2.1 board configuration
# Copyright (c) 2020 InnBlue
# SPDX-License-Identifier: Apache-2.0
if BOARD_INNBLUE21
# For the secure version of the board the firmware is linked at the beginning
# of the flash, or into the code-partition defined in DT if it is intended to
# be loaded by MCUboot. If the secure firmware is to be combined with a non-
# secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always
# be restricted to the size of its code partition.
# For the non-secure version of the board, the firmware
# must be linked into the code-partition (non-secure) defined in DT, regardless.
# Apply this configuration below by setting the Kconfig symbols used by
# the linker according to the information extracted from DT partitions.
# Workaround for not being able to have commas in macro arguments
DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition
if BOARD_INNBLUE21_NRF9160 && TRUSTED_EXECUTION_SECURE
config FLASH_LOAD_SIZE
default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
endif # BOARD_INNBLUE21_NRF9160 && TRUSTED_EXECUTION_SECURE
if BOARD_INNBLUE21_NRF9160_NS
config FLASH_LOAD_OFFSET
default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
config FLASH_LOAD_SIZE
default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION))
endif # BOARD_INNBLUE21_NRF9160_NS
config BT_HCI_VS
default y if BT
config REGULATOR
default y if SENSOR
endif # BOARD_INNBLUE21