| # ST Microelectronics LPS2xDF pressure and temperature sensor |
| |
| # Copyright (c) 2023 STMicroelectronics |
| # Copyright (c) 2023 PHYTEC Messtechnik GmbH |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig LPS2XDF |
| bool "LPS2xDF pressure and temperature" |
| default y |
| depends on DT_HAS_ST_LPS22DF_ENABLED || DT_HAS_ST_LPS28DFW_ENABLED |
| depends on ZEPHYR_HAL_ST_MODULE |
| select I2C if $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS22DF),i2c) ||\ |
| $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS28DFW),i2c) |
| select I2C if $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS22DF),i3c) ||\ |
| $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS28DFW),i3c) |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_ST_LPS22DF),spi) |
| select HAS_STMEMSC |
| select USE_STDC_LPS22DF if DT_HAS_ST_LPS22DF_ENABLED |
| select USE_STDC_LPS28DFW if DT_HAS_ST_LPS28DFW_ENABLED |
| help |
| Enable driver for LPS2xDF I2C-based pressure and temperature |
| sensor. |
| |
| if LPS2XDF |
| |
| choice LPS2XDF_TRIGGER_MODE |
| prompt "Trigger mode" |
| default LPS2XDF_TRIGGER_GLOBAL_THREAD |
| help |
| Specify the type of triggering to be used by the driver. |
| |
| config LPS2XDF_TRIGGER_NONE |
| bool "No trigger" |
| |
| config LPS2XDF_TRIGGER_GLOBAL_THREAD |
| bool "Use global thread" |
| depends on GPIO |
| select LPS2XDF_TRIGGER |
| |
| config LPS2XDF_TRIGGER_OWN_THREAD |
| bool "Use own thread" |
| depends on GPIO |
| select LPS2XDF_TRIGGER |
| |
| endchoice # LPS2XDF_TRIGGER_MODE |
| |
| config LPS2XDF_TRIGGER |
| bool |
| |
| config LPS2XDF_THREAD_PRIORITY |
| int "Thread priority" |
| depends on LPS2XDF_TRIGGER_OWN_THREAD |
| default 10 |
| help |
| Priority of thread used by the driver to handle interrupts. |
| |
| config LPS2XDF_THREAD_STACK_SIZE |
| int "Thread stack size" |
| depends on LPS2XDF_TRIGGER_OWN_THREAD |
| default 1024 |
| help |
| Stack size of thread used by the driver to handle interrupts. |
| |
| endif # LPS2XDF |
