| # Microchip MEC172X MCU core series |
| |
| # Copyright (c) 2021 Microchip Technology Inc. |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| config SOC_SERIES_MEC172X |
| select ARM |
| select CPU_CORTEX_M4 |
| select CPU_CORTEX_M_HAS_DWT |
| select CPU_HAS_FPU |
| select CPU_HAS_ARM_MPU |
| select HAS_SWO |
| select HAS_PM |
| |
| if SOC_SERIES_MEC172X |
| |
| config RTOS_TIMER |
| bool "MEC172x RTOS Timer(32KHz) as kernel timer" |
| |
| choice |
| prompt "MEC172x debug interface general configuration" |
| default SOC_MEC172X_DEBUG_WITHOUT_TRACING |
| depends on SOC_SERIES_MEC172X |
| help |
| Select Debug SoC interface support for MEC172X SoC family |
| |
| config SOC_MEC172X_DEBUG_DISABLED |
| bool "Disable debug support" |
| help |
| Debug port is disabled, JTAG/SWD cannot be enabled. JTAG_RST# |
| pin is ignored. All other JTAG pins can be used as GPIOs |
| or other non-JTAG alternate functions. |
| |
| config SOC_MEC172X_DEBUG_WITHOUT_TRACING |
| bool "Debug support via Serial wire debug" |
| help |
| JTAG port in SWD mode. I2C09 and ADC00-03 can be used. |
| |
| config SOC_MEC172X_DEBUG_AND_TRACING |
| bool "Debug support via Serial wire debug with tracing enabled" |
| help |
| JTAG port is enabled in SWD mode. Refer to tracing options |
| to see if ADC00-03 can be used or not. |
| endchoice |
| |
| choice |
| prompt "MEC172X debug interface trace configuration" |
| default SOC_MEC172X_DEBUG_AND_ETM_TRACING |
| depends on SOC_MEC172X_DEBUG_AND_TRACING |
| help |
| Select tracing mode for debug interface |
| |
| config SOC_MEC172X_DEBUG_AND_ETM_TRACING |
| bool "Debug support via Serial wire debug" |
| help |
| JTAG port in SWD mode and ETM as tracing method. |
| I2C09 can be used, but ADC00-03 cannot. |
| |
| config SOC_MEC172X_DEBUG_AND_SWV_TRACING |
| bool "debug support via Serial Wire Debug and Viewer" |
| help |
| JTAG port in SWD mode and SWV as tracing method. |
| I2C09 cannot be used. ADC00-03 can be used. |
| endchoice |
| |
| # GPIO initialization depends on ECIA initialization, which happen at |
| # CONFIG_KERNEL_INIT_PRIORITY_DEFAULT, so GPIO_INIT_PRIORITY needs to be |
| # higher than that. |
| if GPIO |
| |
| config GPIO_INIT_PRIORITY |
| default 41 |
| |
| endif # GPIO |
| |
| endif # SOC_SERIES_MEC172X |
