dts/bindings/sensor/ti,bq274xx.yaml

#
# Copyright (c) 2020 Linumiz
#
# SPDX-License-Identifier: Apache-2.0
#

description: Texas Instruments BQ274xx Fuel Gauge

compatible: "ti,bq274xx"

include: i2c-device.yaml

properties:
    design-voltage:
      type: int
      required: true
      description: Battery Design Voltage in mV (3300 - 4400)

    design-capacity:
      type: int
      required: true
      description: Battery Design Capacity in mAh

    taper-current:
      type: int
      required: true
      description: Battery Taper current in mAh

    terminate-voltage:
      type: int
      required: true
      description: Battery Terminate Voltage in mV

    int-gpios:
      type: phandle-array
      required: false
      description: |
        The INT signal defaults to active low open drain, so requires a
        pull-up on the board. By default it acts as an output and signals
        specific events happening (e.g. change in State of Charge). While in
        shutdown mode it acts as an input and toggling it will make the sensor
        exit the mode.