dts/bindings/serial/st,stm32-uart-base.yaml

# Copyright (c) 2020 STMICROELECTRONICS
# SPDX-License-Identifier: Apache-2.0

# Common fields for STM32 UART peripherals.
description: STM32 UART-BASE

include: [uart-controller.yaml, pinctrl-device.yaml, reset-device.yaml]

properties:
  reg:
    required: true

  clocks:
    required: true

  resets:
    required: true

  interrupts:
    required: true

  single-wire:
    type: boolean
    description: |
      Enable the single wire half-duplex communication.
      Using this mode, TX and RX lines are internally connected and
      only TX pin is used afterwards and should be configured.
      RX/TX conflicts must be handled on user side.

  tx-rx-swap:
    type: boolean
    description:
      Swap the TX and RX pins. Used in case of a cross wired connection.

  tx-invert:
    type: boolean
    description: |
      Invert the binary logic of tx pin. When enabled, physical logic levels are inverted and
      we use 1=Low, 0=High instead of 1=High, 0=Low.

  rx-invert:
    type: boolean
    description: |
      Invert the binary logic of rx pin. When enabled, physical logic levels are inverted and
      we use 1=Low, 0=High instead of 1=High, 0=Low.

  pinctrl-0:
    required: true

  pinctrl-names:
    required: true

  wakeup-line:
    type: int
    description: |
      EXTI line number matching the device wakeup interrupt mask register.
      This property is required on stm32 devices where the wakeup interrupt signal could be
      configured masked at boot (sm32wl55 for instance), preventing the device to wakeup
      the core from stop mode(s).
      Valid range: 0 - 31

  de-enable:
    type: boolean
    description: |
      Enable activating an external transeiver through the DE pin which must also be configured
      using pinctrl.

  de-assert-time:
    type: int
    default: 0
    description: |
      Defines the time between the activation of the DE signal and the beginning of the start bit.
      It is expressed in 16th of a bit time.
      Valid range: 0 - 31

  de-deassert-time:
    type: int
    default: 0
    description: |
      Defines the time between the activation of the DE signal and the beginning of the start bit.
      It is expressed in 16th of a bit time.
      Valid range: 0 - 31

  de-invert:
    type: boolean
    description: |
      Invert the binary logic of the de pin. When enabled, physical logic levels are inverted and
      we use 1=Low, 0=High instead of 1=High, 0=Low.