| # Kconfig.quark_se_ss - Quark SE Sensor Subsystem I2C configuration options |
| # |
| # |
| # Copyright (c) 2016 Intel Corporation |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| # |
| |
| menuconfig I2C_QUARK_SE_SS |
| bool "I2C Driver for Quark SE Sensor Subsystem (SS)" |
| default n |
| depends on SOC_QUARK_SE_SS |
| depends on I2C |
| help |
| This option enables the driver to support the I2C on Quark SE Sensor |
| Subsystem. |
| |
| if I2C_QUARK_SE_SS |
| |
| config I2C_QUARK_SE_SS_0 |
| bool "Enable Quark SE SS I2C Port 0" |
| depends on I2C_QUARK_SE_SS |
| default n |
| |
| config I2C_QUARK_SE_SS_0_NAME |
| string "Select a name for finding the device" |
| depends on I2C_QUARK_SE_SS_0 |
| default "I2C_SS_0" |
| |
| config I2C_QUARK_SE_SS_0_DEFAULT_CFG |
| hex "Default Configuration for Quark SE SS I2C Port 0" |
| depends on I2C_QUARK_SE_SS_0 |
| default 0x0 |
| help |
| Allows the I2C port to be brought up with a default configuration. |
| This is useful to set if other drivers depend upon using the I2C bus |
| before the application has a chance to custom configure the port. |
| Setting this value does not prohibit the application from customizing |
| the values later. Refer to the I2C datasheet for proper values. |
| |
| config I2C_QUARK_SE_SS_1 |
| bool "Enable Quark SE SS I2C Port 1" |
| depends on I2C_QUARK_SE_SS |
| default n |
| |
| config I2C_QUARK_SE_SS_1_NAME |
| string "Select a name for finding the device" |
| depends on I2C_QUARK_SE_SS_1 |
| default "I2C_SS_1" |
| |
| config I2C_QUARK_SE_SS_1_DEFAULT_CFG |
| hex "Default Configuration for Quark SE SS I2C Port 1" |
| depends on I2C_QUARK_SE_SS_1 |
| default 0x0 |
| help |
| Allows the I2C port to be brought up with a default configuration. |
| This is useful to set if other drivers depend upon using the I2C bus |
| before the application has a chance to custom configure the port. |
| Setting this value does not prohibit the application from customizing |
| the values later. Refer to the I2C datasheet for proper values. |
| |
| endif # I2C_QUARK_SE_SS |