| Title: Installation of ISRs Directly in the Vector Table (ARM Only) |
| |
| Description: |
| |
| Verify a project can install ISRs directly in the vector table. Only for |
| ARM Cortex-M3/4/7/33 targets. |
| |
| --------------------------------------------------------------------------- |
| |
| Building and Running Project: |
| |
| This project outputs to the console. It can be built and executed on QEMU as |
| follows: |
| |
| make run |
| |
| --------------------------------------------------------------------------- |
| |
| Troubleshooting: |
| |
| Problems caused by out-dated project information can be addressed by |
| issuing one of the following commands then rebuilding the project: |
| |
| make clean # discard results of previous builds |
| # but keep existing configuration info |
| or |
| make pristine # discard results of previous builds |
| # and restore pre-defined configuration info |
| |
| --------------------------------------------------------------------------- |
| |
| Sample Output: |
| |
| tc_start() - Test Cortex-M3 IRQ installed directly in vector table |
| isr0 ran! |
| isr1 ran! |
| isr2 ran! |
| PASS - main. |
| =================================================================== |
| PROJECT EXECUTION SUCCESSFUL |
