| # Kconfig - Quark SE C1000 BLE (nRF51822) configuration |
| # |
| # Copyright (c) 2016 Intel Corporation |
| # |
| # Licensed under the Apache License, Version 2.0 (the "License"); |
| # you may not use this file except in compliance with the License. |
| # You may obtain a copy of the License at |
| # |
| # http://www.apache.org/licenses/LICENSE-2.0 |
| # |
| # Unless required by applicable law or agreed to in writing, software |
| # distributed under the License is distributed on an "AS IS" BASIS, |
| # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. |
| # See the License for the specific language governing permissions and |
| # limitations under the License. |
| |
| if BOARD_QUARK_SE_C1000_BLE |
| |
| config BOARD |
| default quark_se_c1000_ble |
| |
| if UART_NRF5 |
| |
| config GPIO |
| default y |
| |
| config GPIO_NRF5 |
| default y |
| |
| config GPIO_NRF5_P0 |
| default y |
| |
| config UART_NRF5_GPIO_TX_PIN |
| default 9 |
| |
| config UART_NRF5_GPIO_RX_PIN |
| default 11 |
| |
| config UART_NRF5_GPIO_RTS_PIN |
| default 8 |
| |
| config UART_NRF5_GPIO_CTS_PIN |
| default 10 |
| |
| endif # UART_NRF5 |
| |
| endif # BOARD_QUARK_SE_C1000_BLE |