| # Kconfig - nRF91 PCA10090 board configuration |
| # |
| # Copyright (c) 2018 Nordic Semiconductor ASA |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| if BOARD_NRF9160_PCA10090 || BOARD_NRF9160_PCA10090NS |
| |
| config BOARD |
| default "nrf9160_pca10090" |
| |
| if ADC |
| |
| config ADC_0 |
| default y |
| |
| endif # ADC |
| |
| if I2C |
| |
| config I2C_2 |
| default y |
| |
| endif # I2C |
| |
| if PWM |
| |
| config PWM_0 |
| default y |
| |
| endif # PWM |
| |
| if SPI |
| |
| config SPI_3 |
| default y |
| |
| endif # SPI |
| |
| # For the secure version of the board the firmware is linked at the beginning |
| # of the flash, or into the code-partition defined in DT if it is intended to |
| # be loaded by MCUboot. If the secure firmware is to be combined with a non- |
| # secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always |
| # be restricted to the size of its code partition. |
| # For the non-secure version of the board, the firmware |
| # must be linked into the code-partition (non-secure) defined in DT, regardless. |
| # Apply this configuration below by setting the Kconfig symbols used by |
| # the linker according to the information extracted from DT partitions. |
| |
| if BOARD_NRF9160_PCA10090 && TRUSTED_EXECUTION_SECURE |
| |
| config FLASH_LOAD_SIZE |
| default $(dt_hex_val,DT_CODE_PARTITION_SIZE) |
| |
| endif # BOARD_NRF9160_PCA10090 && TRUSTED_EXECUTION_SECURE |
| |
| if BOARD_NRF9160_PCA10090NS |
| |
| config FLASH_LOAD_OFFSET |
| default $(dt_hex_val,DT_CODE_PARTITION_OFFSET) |
| |
| config FLASH_LOAD_SIZE |
| default $(dt_hex_val,DT_CODE_PARTITION_SIZE) |
| |
| endif # BOARD_NRF9160_PCA10090NS |
| |
| endif # BOARD_NRF9160_PCA10090 || BOARD_NRF9160_PCA10090NS |