| .. zephyr:board:: kb1062_evb |
| |
| Overview |
| ******** |
| |
| The KB1062_EVB kit is a development platform to evaluate the |
| ENE KB106X series microcontrollers. This board needs to be mated with |
| part number KB1062. |
| |
| Hardware |
| ******** |
| |
| - ARM Cortex-M3 Processor |
| - 256KB Flash and 64KB RAM |
| - ADC & GPIO headers |
| - SER serial port |
| - FAN PWM interface |
| - ENE Debug interface |
| |
| Supported Features |
| ================== |
| |
| .. zephyr:board-supported-hw:: |
| |
| System Clock |
| ============ |
| |
| The KB106x MCU is configured to use the 48Mhz internal oscillator with the |
| on-chip DPLL to generate a resulting EC clock rate of 48MHz/24MHz |
| See Processor clock control register (refer 5.1 General Configuration) |
| |
| Programming and Debugging |
| ************************* |
| |
| .. zephyr:board-supported-runners:: |
| |
| Flashing |
| ======== |
| |
| If the correct headers are installed, this board supports SWD Debug Interface. |
| |
| To flash with SWD, install the drivers for your programmer, for example: |
| SEGGER J-link's drivers are at https://www.segger.com/downloads/jlink/ |
| |
| Debugging |
| ========= |
| |
| Use SWD with a J-Link |
| |
| References |
| ========== |
| |
| .. target-notes:: |
