| Bluetooth: Broadcast Audio Profile Scan Delegator |
| ################################################# |
| |
| This document describes how to run the Scan Delegator functionality, Note that |
| in the examples below, some lines of debug have been |
| removed to make this shorter and provide a better overview. |
| |
| The Scan Delegator may optionally support the periodic advertisements |
| synchronization transfer (PAST) protocol. |
| |
| The Scan Delegator server typically resides on devices that have inputs or |
| outputs. |
| |
| It is necessary to have :code:`BT_DEBUG_BAP_SCAN_DELEGATOR` enabled for using |
| the Scan Delegator interactively. |
| |
| The Scan Delegator can currently only set the sync state of a receive state, but |
| does not actually support syncing with periodic advertisements yet. |
| |
| .. code-block:: console |
| |
| bap_scan_delegator --help |
| bap_scan_delegator - Bluetooth BAP Scan Delegator shell commands |
| Subcommands: |
| init :Initialize the service and register callbacks |
| synced :Set server scan state <src_id> <pa_synced> <bis_syncs> <enc_state> |
| |
| |
| Example Usage |
| ************* |
| |
| Setup |
| ===== |
| |
| .. code-block:: console |
| |
| uart:~$ bt init |
| uart:~$ bt advertise on |
| Advertising started |
| |
| When connected |
| ============== |
| |
| Set sync state for a source: |
| |
| .. code-block:: console |
| |
| uart:~$ bap_scan_delegator synced 0 1 3 0 |
