| /* |
| * Copyright (c) 2016 Freescale Semiconductor, Inc. |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #include <init.h> |
| #include <pinmux.h> |
| #include <gpio.h> |
| #include <fsl_port.h> |
| |
| static int hexiwear_k64_pinmux_init(struct device *dev) |
| { |
| ARG_UNUSED(dev); |
| |
| #ifdef CONFIG_PINMUX_MCUX_PORTA |
| struct device *porta = |
| device_get_binding(CONFIG_PINMUX_MCUX_PORTA_NAME); |
| #endif |
| #ifdef CONFIG_PINMUX_MCUX_PORTB |
| struct device *portb = |
| device_get_binding(CONFIG_PINMUX_MCUX_PORTB_NAME); |
| #endif |
| #ifdef CONFIG_PINMUX_MCUX_PORTC |
| struct device *portc = |
| device_get_binding(CONFIG_PINMUX_MCUX_PORTC_NAME); |
| #endif |
| #ifdef CONFIG_PINMUX_MCUX_PORTD |
| struct device *portd = |
| device_get_binding(CONFIG_PINMUX_MCUX_PORTD_NAME); |
| #endif |
| #ifdef CONFIG_PINMUX_MCUX_PORTE |
| struct device *porte = |
| device_get_binding(CONFIG_PINMUX_MCUX_PORTE_NAME); |
| #endif |
| |
| #ifdef CONFIG_PWM_3 |
| /* Red, green, blue LEDs as PWM channels */ |
| pinmux_pin_set(portc, 8, PORT_PCR_MUX(kPORT_MuxAlt3)); |
| pinmux_pin_set(portc, 9, PORT_PCR_MUX(kPORT_MuxAlt3)); |
| pinmux_pin_set(portd, 0, PORT_PCR_MUX(kPORT_MuxAlt4)); |
| #else |
| /* Red, green, blue LEDs as GPIOs */ |
| pinmux_pin_set(portc, 8, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| pinmux_pin_set(portc, 9, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| pinmux_pin_set(portd, 0, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| #endif |
| |
| #if CONFIG_I2C_0 |
| /* I2C0 SCL, SDA - heart rate, light, humidity */ |
| pinmux_pin_set(portb, 0, PORT_PCR_MUX(kPORT_MuxAlt2) |
| | PORT_PCR_ODE_MASK); |
| pinmux_pin_set(portb, 1, PORT_PCR_MUX(kPORT_MuxAlt2) |
| | PORT_PCR_ODE_MASK); |
| |
| /* 3V3B_EN */ |
| pinmux_pin_set(portb, 12, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| |
| struct device *gpiob = device_get_binding(GPIO_B_LABEL); |
| |
| gpio_pin_configure(gpiob, 12, GPIO_DIR_OUT); |
| gpio_pin_write(gpiob, 12, 0); |
| #endif |
| |
| #if CONFIG_I2C_1 |
| /* I2C1 SCL, SDA - accel/mag, gyro, pressure */ |
| pinmux_pin_set(portc, 10, PORT_PCR_MUX(kPORT_MuxAlt2) |
| | PORT_PCR_ODE_MASK); |
| pinmux_pin_set(portc, 11, PORT_PCR_MUX(kPORT_MuxAlt2) |
| | PORT_PCR_ODE_MASK); |
| #endif |
| /* FXAS21002 INT2 */ |
| pinmux_pin_set(portc, 18, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| |
| /* FXOS8700 INT2 */ |
| pinmux_pin_set(portd, 13, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| |
| #ifdef CONFIG_UART_MCUX_0 |
| /* UART0 RX, TX */ |
| pinmux_pin_set(portb, 16, PORT_PCR_MUX(kPORT_MuxAlt3)); |
| pinmux_pin_set(portb, 17, PORT_PCR_MUX(kPORT_MuxAlt3)); |
| #endif |
| |
| #ifdef CONFIG_UART_MCUX_4 |
| /* UART4 RX, TX - BLE */ |
| pinmux_pin_set(porte, 24, PORT_PCR_MUX(kPORT_MuxAlt3)); |
| pinmux_pin_set(porte, 25, PORT_PCR_MUX(kPORT_MuxAlt3)); |
| #endif |
| |
| #ifdef CONFIG_MAX30101 |
| /* LDO - MAX30101 power supply */ |
| pinmux_pin_set(porta, 29, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| |
| struct device *gpioa = device_get_binding(GPIO_A_LABEL); |
| |
| gpio_pin_configure(gpioa, 29, GPIO_DIR_OUT); |
| gpio_pin_write(gpioa, 29, 1); |
| #endif |
| |
| #ifdef CONFIG_BATTERY_SENSE |
| pinmux_pin_set(portc, 14, PORT_PCR_MUX(kPORT_MuxAsGpio)); |
| |
| struct device *gpioc = device_get_binding(GPIO_C_LABEL); |
| |
| gpio_pin_configure(gpioc, 14, GPIO_DIR_OUT); |
| gpio_pin_write(gpioc, 14, 0); |
| #endif |
| |
| return 0; |
| } |
| |
| SYS_INIT(hexiwear_k64_pinmux_init, PRE_KERNEL_1, CONFIG_PINMUX_INIT_PRIORITY); |