| /* |
| * Copyright (c) 2016 Jean-Paul Etienne <fractalclone@gmail.com> |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #ifndef __INC_BOARD_H |
| #define __INC_BOARD_H |
| |
| #include <soc.h> |
| #include <gpio.h> |
| |
| /* LEDS configuration */ |
| #define LED0_GPIO_PORT "gpio0" |
| #define LED1_GPIO_PORT "gpio0" |
| #define LED2_GPIO_PORT "gpio0" |
| #define LED3_GPIO_PORT "gpio0" |
| #define LED4_GPIO_PORT "gpio0" |
| #define LED5_GPIO_PORT "gpio0" |
| #define LED6_GPIO_PORT "gpio0" |
| #define LED7_GPIO_PORT "gpio0" |
| |
| #define LED0_GPIO_PIN 8 |
| #define LED1_GPIO_PIN 9 |
| #define LED2_GPIO_PIN 10 |
| #define LED3_GPIO_PIN 11 |
| #define LED4_GPIO_PIN 12 |
| #define LED5_GPIO_PIN 13 |
| #define LED6_GPIO_PIN 14 |
| #define LED7_GPIO_PIN 15 |
| |
| /* Push buttons configuration */ |
| #define SW0_GPIO_NAME "gpio0" |
| #define SW1_GPIO_NAME "gpio0" |
| #define SW2_GPIO_NAME "gpio0" |
| #define SW3_GPIO_NAME "gpio0" |
| #define SW4_GPIO_NAME "gpio0" |
| |
| #define SW0_GPIO_PIN 16 |
| #define SW1_GPIO_PIN 17 |
| #define SW2_GPIO_PIN 18 |
| #define SW3_GPIO_PIN 19 |
| #define SW4_GPIO_PIN 20 |
| |
| /* |
| * GPIO PULL-UP config does not exist in pulpino |
| * set all to 1 for buttons to compile against apps. |
| */ |
| #define SW0_GPIO_PULL_UP 1 |
| #define SW1_GPIO_PULL_UP 1 |
| #define SW2_GPIO_PULL_UP 1 |
| #define SW3_GPIO_PULL_UP 1 |
| #define SW4_GPIO_PULL_UP 1 |
| |
| /* Interrupt config for push buttons */ |
| #define SW0_GPIO_INT_CONF (GPIO_INT_EDGE | GPIO_INT_ACTIVE_HIGH) |
| #define SW1_GPIO_INT_CONF SW0_GPIO_INT_CONF |
| #define SW2_GPIO_INT_CONF SW0_GPIO_INT_CONF |
| #define SW3_GPIO_INT_CONF SW0_GPIO_INT_CONF |
| #define SW4_GPIO_INT_CONF SW0_GPIO_INT_CONF |
| |
| #endif /* __INC_BOARD_H */ |
