| /* |
| * Copyright (c) 2022 Vestas Wind Systems A/S |
| * Copyright (c) 2021 Alexander Wachter |
| * Copyright (c) 2022 Kamil Serwus |
| * |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| #include <zephyr/drivers/can.h> |
| #include <zephyr/drivers/pinctrl.h> |
| #include <zephyr/irq.h> |
| #include <zephyr/kernel.h> |
| #include <zephyr/logging/log.h> |
| #include <soc.h> |
| |
| #include "can_mcan.h" |
| |
| LOG_MODULE_REGISTER(can_sam0, CONFIG_CAN_LOG_LEVEL); |
| |
| #define DT_DRV_COMPAT atmel_sam0_can |
| |
| struct can_sam0_config { |
| mm_reg_t base; |
| void (*config_irq)(void); |
| const struct pinctrl_dev_config *pcfg; |
| volatile uint32_t *mclk; |
| uint32_t mclk_mask; |
| uint16_t gclk_core_id; |
| int divider; |
| }; |
| |
| struct can_sam0_data { |
| struct can_mcan_msg_sram msg_ram; |
| }; |
| |
| static int can_sam0_read_reg(const struct device *dev, uint16_t reg, uint32_t *val) |
| { |
| const struct can_mcan_config *mcan_config = dev->config; |
| const struct can_sam0_config *sam_config = mcan_config->custom; |
| |
| return can_mcan_sys_read_reg(sam_config->base, reg, val); |
| } |
| |
| static int can_sam0_write_reg(const struct device *dev, uint16_t reg, uint32_t val) |
| { |
| const struct can_mcan_config *mcan_config = dev->config; |
| const struct can_sam0_config *sam_config = mcan_config->custom; |
| uint32_t bits = 0U; |
| |
| switch (reg) { |
| case CAN_MCAN_ILS: |
| /* All interrupts are assigned to MCAN_INT0 */ |
| val = 0; |
| break; |
| case CAN_MCAN_ILE: |
| /* SAM0 has only one line to handle interrupts */ |
| val = CAN_MCAN_ILE_EINT0; |
| break; |
| default: |
| /* No field remap needed */ |
| bits = val; |
| break; |
| }; |
| |
| return can_mcan_sys_write_reg(sam_config->base, reg, val); |
| } |
| |
| void can_sam0_line_x_isr(const struct device *dev) |
| { |
| can_mcan_line_0_isr(dev); |
| can_mcan_line_1_isr(dev); |
| } |
| |
| static int can_sam0_get_core_clock(const struct device *dev, uint32_t *rate) |
| { |
| const struct can_mcan_config *mcan_cfg = dev->config; |
| const struct can_sam0_config *sam_cfg = mcan_cfg->custom; |
| |
| *rate = SOC_ATMEL_SAM0_OSC48M_FREQ_HZ / (sam_cfg->divider); |
| |
| return 0; |
| } |
| |
| static void can_sam0_clock_enable(const struct can_sam0_config *cfg) |
| { |
| /* Enable the GLCK7 with DIV*/ |
| GCLK->GENCTRL[7].reg = GCLK_GENCTRL_SRC(GCLK_GENCTRL_SRC_OSC48M) |
| | GCLK_GENCTRL_DIV(cfg->divider) |
| | GCLK_GENCTRL_GENEN; |
| |
| /* Route channel */ |
| GCLK->PCHCTRL[cfg->gclk_core_id].reg = GCLK_PCHCTRL_GEN_GCLK7 |
| | GCLK_PCHCTRL_CHEN; |
| |
| /* Enable CAN clock in MCLK */ |
| *cfg->mclk |= cfg->mclk_mask; |
| } |
| |
| static int can_sam0_init(const struct device *dev) |
| { |
| const struct can_mcan_config *mcan_cfg = dev->config; |
| const struct can_sam0_config *sam_cfg = mcan_cfg->custom; |
| int ret; |
| |
| can_sam0_clock_enable(sam_cfg); |
| |
| ret = pinctrl_apply_state(sam_cfg->pcfg, PINCTRL_STATE_DEFAULT); |
| if (ret < 0) { |
| LOG_ERR("failed to apply pinctrl"); |
| return ret; |
| } |
| |
| ret = can_mcan_configure_message_ram(dev, 0U); |
| if (ret != 0) { |
| LOG_ERR("failed to configure message ram"); |
| return ret; |
| } |
| |
| ret = can_mcan_init(dev); |
| if (ret != 0) { |
| LOG_ERR("failed to mcan init"); |
| return ret; |
| } |
| |
| sam_cfg->config_irq(); |
| |
| return ret; |
| } |
| |
| static const struct can_driver_api can_sam0_driver_api = { |
| .get_capabilities = can_mcan_get_capabilities, |
| .start = can_mcan_start, |
| .stop = can_mcan_stop, |
| .set_mode = can_mcan_set_mode, |
| .set_timing = can_mcan_set_timing, |
| .send = can_mcan_send, |
| .add_rx_filter = can_mcan_add_rx_filter, |
| .remove_rx_filter = can_mcan_remove_rx_filter, |
| .get_state = can_mcan_get_state, |
| #ifndef CONFIG_CAN_AUTO_BUS_OFF_RECOVERY |
| .recover = can_mcan_recover, |
| #endif /* CONFIG_CAN_AUTO_BUS_OFF_RECOVERY */ |
| .get_core_clock = can_sam0_get_core_clock, |
| .get_max_filters = can_mcan_get_max_filters, |
| .get_max_bitrate = can_mcan_get_max_bitrate, |
| .set_state_change_callback = can_mcan_set_state_change_callback, |
| .timing_min = { |
| .sjw = 0x1, |
| .prop_seg = 0x00, |
| .phase_seg1 = 0x01, |
| .phase_seg2 = 0x01, |
| .prescaler = 0x01 |
| }, |
| .timing_max = { |
| .sjw = 0x7f, |
| .prop_seg = 0x00, |
| .phase_seg1 = 0x100, |
| .phase_seg2 = 0x80, |
| .prescaler = 0x200 |
| }, |
| #ifdef CONFIG_CAN_FD_MODE |
| .set_timing_data = can_mcan_set_timing_data, |
| .timing_data_min = { |
| .sjw = 0x01, |
| .prop_seg = 0x00, |
| .phase_seg1 = 0x01, |
| .phase_seg2 = 0x01, |
| .prescaler = 0x01 |
| }, |
| .timing_data_max = { |
| .sjw = 0x10, |
| .prop_seg = 0x00, |
| .phase_seg1 = 0x20, |
| .phase_seg2 = 0x10, |
| .prescaler = 0x20 |
| } |
| #endif /* CONFIG_CAN_FD_MODE */ |
| }; |
| |
| #define CAN_SAM0_IRQ_CFG_FUNCTION(inst) \ |
| static void config_can_##inst##_irq(void) \ |
| { \ |
| LOG_DBG("Enable CAN##inst## IRQ"); \ |
| IRQ_CONNECT(DT_INST_IRQ_BY_NAME(inst, line_0, irq), \ |
| DT_INST_IRQ_BY_NAME(inst, line_0, priority), can_sam0_line_x_isr, \ |
| DEVICE_DT_INST_GET(inst), 0); \ |
| irq_enable(DT_INST_IRQ_BY_NAME(inst, line_0, irq)); \ |
| } |
| |
| #define CAN_SAM0_CFG_INST(inst) \ |
| static const struct can_sam0_config can_sam0_cfg_##inst = { \ |
| .base = (mm_reg_t)DT_INST_REG_ADDR(inst), \ |
| .mclk = (volatile uint32_t *)MCLK_MASK_DT_INT_REG_ADDR(inst), \ |
| .mclk_mask = BIT(DT_INST_CLOCKS_CELL_BY_NAME(inst, mclk, bit)), \ |
| .gclk_core_id = DT_INST_CLOCKS_CELL_BY_NAME(inst, gclk, periph_ch), \ |
| .divider = DT_INST_PROP(inst, divider), \ |
| .pcfg = PINCTRL_DT_INST_DEV_CONFIG_GET(inst), \ |
| .config_irq = config_can_##inst##_irq, \ |
| }; \ |
| \ |
| static const struct can_mcan_config can_mcan_cfg_##inst = \ |
| CAN_MCAN_DT_CONFIG_INST_GET(inst, &can_sam0_cfg_##inst, \ |
| can_sam0_read_reg, \ |
| can_sam0_write_reg); |
| |
| #define CAN_SAM0_DATA_INST(inst) \ |
| static struct can_sam0_data can_sam0_data_##inst; \ |
| \ |
| static struct can_mcan_data can_mcan_data_##inst = \ |
| CAN_MCAN_DATA_INITIALIZER(&can_sam0_data_##inst.msg_ram, \ |
| &can_sam0_data_##inst); \ |
| |
| #define CAN_SAM0_DEVICE_INST(inst) \ |
| DEVICE_DT_INST_DEFINE(inst, &can_sam0_init, NULL, \ |
| &can_mcan_data_##inst, \ |
| &can_mcan_cfg_##inst, \ |
| POST_KERNEL, CONFIG_CAN_INIT_PRIORITY, \ |
| &can_sam0_driver_api); |
| |
| #define CAN_SAM0_INST(inst) \ |
| PINCTRL_DT_INST_DEFINE(inst); \ |
| CAN_SAM0_IRQ_CFG_FUNCTION(inst) \ |
| CAN_SAM0_CFG_INST(inst) \ |
| CAN_SAM0_DATA_INST(inst) \ |
| CAN_SAM0_DEVICE_INST(inst) |
| |
| DT_INST_FOREACH_STATUS_OKAY(CAN_SAM0_INST) |