| # Zephyr Kernel Configuration |
| CONFIG_ARM=y |
| CONFIG_ARCH="arm" |
| CONFIG_SOC="stm32f373xc" |
| CONFIG_SOC_SERIES="stm32f3" |
| CONFIG_SOC_FAMILY="st_stm32" |
| CONFIG_BOARD="stm32373c_eval" |
| CONFIG_SOC_SERIES_STM32F3X=y |
| |
| # Platform Configuration |
| CONFIG_SOC_FAMILY_STM32=y |
| CONFIG_SOC_STM32F373XC=y |
| CONFIG_BOARD_STM32373C_EVAL=y |
| |
| # ARM Options |
| CONFIG_CPU_HAS_FPU=y |
| |
| # Floating Point Options |
| CONFIG_FLOAT=y |
| |
| # General Kernel Options |
| CONFIG_CORTEX_M_SYSTICK=y |
| CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000 |
| |
| # Serial Drivers |
| CONFIG_SERIAL=y |
| CONFIG_SERIAL_HAS_DRIVER=y |
| CONFIG_UART_INTERRUPT_DRIVEN=y |
| CONFIG_UART_STM32=y |
| # enable USART2 - passthrough to STLINK v2 connector |
| CONFIG_UART_STM32_PORT_2=y |
| CONFIG_UART_STM32_PORT_2_NAME="UART_2" |
| # enable console on this port by default |
| CONFIG_CONSOLE=y |
| CONFIG_UART_CONSOLE=y |
| |
| # Pinmux Driver |
| CONFIG_PINMUX=y |
| CONFIG_PINMUX_STM32=y |
| |
| # GPIO Controller |
| CONFIG_GPIO=y |
| CONFIG_GPIO_STM32=y |
| CONFIG_GPIO_STM32_PORTA=y |
| CONFIG_GPIO_STM32_PORTB=y |
| CONFIG_GPIO_STM32_PORTC=y |
| CONFIG_GPIO_STM32_PORTD=y |
| CONFIG_GPIO_STM32_PORTE=y |
| |
| # Clock configuration |
| CONFIG_CLOCK_CONTROL=y |
| # SYSCLK selection |
| CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y |
| # HSE configuration |
| CONFIG_CLOCK_STM32_HSE_CLOCK=8000000 |
| # PLL configuration |
| CONFIG_CLOCK_STM32_PLL_SRC_HSE=y |
| # produce 72MHz clock at PLL output |
| CONFIG_CLOCK_STM32_PLL_PREDIV=1 |
| CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9 |
| CONFIG_CLOCK_STM32_AHB_PRESCALER=1 |
| CONFIG_CLOCK_STM32_APB1_PRESCALER=2 |
| CONFIG_CLOCK_STM32_APB2_PRESCALER=2 |