| # Copyright (c) 2021 STMicroelectronics |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| description: | |
| When setting the odr property in a .dts or .dtsi file you may include |
| lps22hh.h and use the macros defined there. |
| |
| Example: |
| #include <zephyr/dt-bindings/sensor/lps22hh.h> |
| |
| lps22hh: lps22hh@0 { |
| ... |
| |
| odr = <LPS22HH_DT_ODR_200HZ>; |
| }; |
| |
| include: sensor-device.yaml |
| |
| properties: |
| drdy-gpios: |
| type: phandle-array |
| description: | |
| DRDY pin |
| |
| This pin defaults to active high when produced by the sensor. |
| The property value should ensure the flags properly describe |
| the signal that is presented to the driver. |
| |
| odr: |
| type: int |
| default: 0 |
| description: | |
| Specify the default output data rate expressed in samples per second (Hz). |
| The default is the power-on reset value. |
| |
| - 0 # LPS22HH_DT_ODR_POWER_DOWN |
| - 1 # LPS22HH_DT_ODR_1HZ |
| - 2 # LPS22HH_DT_ODR_10HZ |
| - 3 # LPS22HH_DT_ODR_25HZ |
| - 4 # LPS22HH_DT_ODR_50HZ |
| - 5 # LPS22HH_DT_ODR_75HZ |
| - 6 # LPS22HH_DT_ODR_100HZ |
| - 7 # LPS22HH_DT_ODR_200HZ |
| |
| enum: [0, 1, 2, 3, 4, 5, 6, 7] |