| # |
| # Copyright 2018-2022 NXP |
| # |
| # SPDX-License-Identifier: Apache-2.0 |
| # |
| |
| if (CONFIG_DISPLAY) |
| message(WARNING " |
| CONFIG_DISPLAY: Running this firmware on a board without a display may damage the board |
| ") |
| endif() |
| |
| if(CONFIG_NXP_IMX_RT_BOOT_HEADER) |
| zephyr_library() |
| if(NOT DEFINED CONFIG_BOARD_MIMXRT1064_EVK) |
| message(WARNING "It appears you are using the board definition for " |
| "the MIMXRT1064-EVK, but targeting a custom board. You may need to " |
| "update your flash configuration or device configuration data blocks") |
| endif() |
| set(RT1064_BOARD_DIR |
| "${ZEPHYR_HAL_NXP_MODULE_DIR}/mcux/mcux-sdk/boards/evkmimxrt1064") |
| if(CONFIG_BOOT_FLEXSPI_NOR) |
| # Include flash configuration block for RT1064 EVK from NXP's HAL. |
| # This configuration block may need modification if another flash chip is |
| # used on your custom board. See NXP AN12238 for more information. |
| zephyr_compile_definitions(XIP_BOOT_HEADER_ENABLE=1) |
| zephyr_compile_definitions(BOARD_FLASH_SIZE=CONFIG_FLASH_SIZE*1024) |
| zephyr_library_sources(${RT1064_BOARD_DIR}/xip/evkmimxrt1064_flexspi_nor_config.c) |
| zephyr_library_include_directories(${RT1064_BOARD_DIR}/xip) |
| endif() |
| if(CONFIG_DEVICE_CONFIGURATION_DATA) |
| # Include device configuration data block for RT1064 EVK from NXP's HAL. |
| # This configuration block may need modification if another SDRAM chip |
| # is used on your custom board. |
| zephyr_compile_definitions(XIP_BOOT_HEADER_DCD_ENABLE=1) |
| zephyr_library_sources(${RT1064_BOARD_DIR}/dcd.c) |
| endif() |
| endif() |
