| # Copyright (c) 2021 STMicroelectronics |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| include: sensor-device.yaml |
| |
| properties: |
| irq-gpios: |
| type: phandle-array |
| description: | |
| DRDY pin |
| |
| This pin defaults to active high when produced by the sensor. |
| The property value should ensure the flags properly describe |
| the signal that is presented to the driver. |
| |
| range: |
| type: int |
| default: 2 |
| description: | |
| Range in g. Default is power-up configuration. |
| |
| enum: |
| - 16 # 16g (0.488 mg/LSB) |
| - 8 # 8g (0.244 mg/LSB) |
| - 4 # 4g (0.122 mg/LSB) |
| - 2 # 2g (0.061 mg/LSB) |
| |
| power-mode: |
| type: int |
| default: 0 |
| description: | |
| Specify the sensor power mode. Default is power-down mode |
| |
| enum: |
| - 0 # Power Down (PD) |
| - 1 # Low Power (LP) |
| - 2 # High Resolution (HR) |
| - 3 # High Frequency (HF) |
| |
| odr: |
| type: int |
| default: 0 |
| description: | |
| Specify the default output data rate expressed in samples per second (Hz). |
| Default is power-down mode |
| enum: |
| - 0 # Power-Down |
| - 1 # 1Hz (available in LP mode only) |
| - 2 # 12.5Hz (available in LP and HR mode) |
| - 3 # 25Hz (available in LP and HR mode) |
| - 4 # 50Hz (available in LP and HR mode) |
| - 5 # 100Hz (available in LP and HR mode) |
| - 6 # 200Hz (available in LP and HR mode) |
| - 7 # 400Hz (available in LP and HR mode) |
| - 8 # 800Hz (available in LP and HR mode) |
| - 9 # 1600Hz (available in HF mode only) |
| - 10 # 3200Hz (available in HF mode only) |
| - 11 # 6400Hz (available in HF mode only) |
