| # Distributed Switch Architecture [DSA] configuration options |
| |
| # Copyright (c) 2020 DENX Software Engineering GmbH |
| # Lukasz Majewski <lukma@denx.de> |
| # SPDX-License-Identifier: Apache-2.0 |
| |
| menuconfig NET_DSA |
| bool "Distributed Switch Architecture support" |
| depends on ETH_MCUX || ETH_SAM_GMAC |
| help |
| Enable Distributed Switch Architecture support. For now it |
| only supports Kinetics ENET driver. |
| |
| if NET_DSA |
| |
| config DSA_KSZ8XXX |
| bool |
| |
| config DSA_KSZ8794 |
| bool "Support for KSZ8794" |
| default y |
| depends on DT_HAS_MICROCHIP_KSZ8794_ENABLED |
| select DSA_KSZ8XXX |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_MICROCHIP_KSZ8794),spi) |
| help |
| Add support for KSZ8794 DSA device driver. |
| |
| config DSA_KSZ8863 |
| bool "Support for KSZ8863" |
| default y |
| depends on DT_HAS_MICROCHIP_KSZ8863_ENABLED |
| select DSA_KSZ8XXX |
| select SPI if $(dt_compat_on_bus,$(DT_COMPAT_MICROCHIP_KSZ8863),spi) |
| help |
| Add support for KSZ8863 DSA device driver. |
| |
| config DSA_KSZ_TAIL_TAGGING |
| bool "Support for tail tagging" |
| depends on DSA_KSZ8794 || DSA_KSZ8863 |
| help |
| Add support for tail tagging on DSA device. |
| |
| config DSA_SPI |
| bool "Support for PHY SPI interface" |
| depends on SPI && (DSA_KSZ8794 || DSA_KSZ8863) |
| help |
| Use SPI bus to communicate with PHY |
| |
| module = NET_DSA |
| module-dep = NET_LOG |
| module-str = Log level for DSA |
| module-help = Enables core DSA code to output debug messages. |
| source "subsys/net/Kconfig.template.log_config.net" |
| |
| endif # NET_DSA |
