| I2C Slave API test |
| ################## |
| |
| This test verifies I2C slave driver implementations using two I2C |
| controllers on a common bus. The test is supported by a test-specific |
| driver that simulates an EEPROM with an I2C bus follower ("slave") |
| interface. Data is pre-loaded into the simulated devices outside the |
| I2C API, and the Zephyr application issues commands to one controller |
| that are responded to by the simulated EEPROM connected through the |
| other controller. |
| |
| In slightly more detail the test has these phases: |
| |
| * Use API specific to the simulated EEPROM to pre-populate the simulated |
| devices with device-specific content. |
| * Register each simulated EEPROM as a I2C follower device on a bus. |
| * Issue commands on one bus controller (operating as the bus leader |
| (master)) and verify that the data supplied by the other controller |
| (as bus follower) match the expected values given the content known to |
| be present on the simulated device. |
| |
| Transfer of commands from one bus controller to the other is |
| accomplished by hardware through having the SCL (and SDA) signals |
| shorted to join the two buses. |
| |
| Presence of this required hardware configuration is identified by the |
| `i2c_bus_short` fixture. If the buses are not connected as required, |
| or the controller driver has bugs, the test will fail one or more I2C |
| transactions. |
