| /* |
| * Copyright (c) 2016 Piotr Mienkowski |
| * SPDX-License-Identifier: Apache-2.0 |
| */ |
| |
| /** @file |
| * @brief System module to support early Atmel SAM E70 MCU configuration |
| */ |
| |
| #include <device.h> |
| #include <init.h> |
| #include <soc.h> |
| #include <arch/cpu.h> |
| |
| /** |
| * @brief Perform SoC configuration at boot. |
| * |
| * This should be run early during the boot process but after basic hardware |
| * initialization is done. |
| * |
| * @return 0 |
| */ |
| static int atmel_same70_config(struct device *dev) |
| { |
| #ifdef CONFIG_SOC_ATMEL_SAME70_DISABLE_ERASE_PIN |
| /* Disable ERASE function on PB12 pin, this is controlled by Bus Matrix */ |
| MATRIX->CCFG_SYSIO |= CCFG_SYSIO_SYSIO12; |
| #endif |
| |
| /* In Cortex-M based SoCs JTAG interface can be used to perform |
| * IEEE1149.1 JTAG Boundary scan only. It can not be used as a debug |
| * interface therefore there is no harm done by disabling the JTAG TDI |
| * pin by default. |
| */ |
| /* Disable TDI function on PB4 pin, this is controlled by Bus Matrix */ |
| MATRIX->CCFG_SYSIO |= CCFG_SYSIO_SYSIO4; |
| |
| return 0; |
| } |
| |
| SYS_INIT(atmel_same70_config, PRE_KERNEL_1, 1); |